A、Terms of vehicles with raised rubber installation diagram
 
 
 
 
 B、Suitable for door hatchback sedan car-free projection strips
 
 
 
 
 
[Installation]:
1 environment
  Operation of this product must be installed in fine weather， guaranteed to be affixed to the surface of absolutely dry， were below the non-dust conditions.
  2 Analog
  Before the paste operation， it is necessary to simulate the product installation process. Check posts and the posts thereof object is consistent. If the adhesion between the 3M adhesive with the posts thereof， determine the installation location and then carry out the next step.
  3 cleaning process
  First with a clean， dry cloth to wipe the surface to be posted， then products with the treatment agent and a soft thin paper that will be pasted to the place to scrub. And other treatment agents completely dry before installation.
  4 Paste
  After determining the installation location， release paper torn corner， the installation should stick side torn plastic edge to ensure that all parts of the product and be able to quote parts of adhesion. After the paste and then the product necessary to make sure if pressed.
  Temperature set at less than 15 degrees Kelvin， usable products and 3M adhesive duct preheated 5 as installed.
  6 After the installation of retention
  Within 24 hours after completion of the installation do not touch the water and larger dust， in order to ensure the best resultsa