MKS-Gen2Z V1.1

Name: 3D printer control board MKS-Gen2Z V1.1

Purchasing Notice:
1. MKS - Gen2Z is a customized product, which is specially based on MKS - Gen , especially suitable for singles  head, two Z axis 3D printers

2. The two Z axis motor can be connected to the Z moter 1 and 2 respectively,  the other functions are exactly the same with MKS - Gen 
 
 
MKS GEN

Overview
MKS Gen is a feature rich all-in-one electronics solution for Reprap and other CNC devices.

It features an onboard ATmega2560. Its five motor outputs are powered by Pololu pin compatible stepper drivers.

The board features a developer friendly expansion port supporting giving access the same as Ramps1.4.

MKS Gen is designed to be flexible in the user's power source availability, allowing any power supply from 12V-24V.

MKS Gen retains all interface of ramps1.4.
 

Features

Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware

1.Firmware can use the same configuration as ramps1.4

2.Easy DISPLAY + SD-CARD connector, RepRapDiscount

3.SmartController compatible pin header on board

4.Easy connect MKS TFT on AUX-1

5.All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)

6. 3x temperature ADC connectors for thermistors
up to 5 motor driver with easy micro stepping setup (micro switches)

7. 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)

8. 4 layers PCB, optimize heat dissipation.

9. 3* 5V output, 3* 12V-24V output interface.

10. 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
11. Recoverable fuse for short-circuit protection.