U is used to trim the sides of the beard hair on the temples.

Power supply u to push open the shaver， to promote repair temples knifeswitch， veneer shaving.

Charge.

The U razor normal charging 8 hours， rated voltage of 220V 50HZ.

U charging at the temperature of 5-35C

U to ensure safety， you must keep the shaver with charging plug drying.

U charging must turn off the switch. Charging indicator light means the charging start.

Cleaning and maintenance:

Use the cleaning brush to clean the body， head， do not wash the knife knife netnet so as to avoid breakage.

Shaver replacement parts:

The cutter head and the knife net wear， please feel free to replace the shavingfunction to maintain.

1 replacing the knife net:

Press the outer foil release button (opening and closing button)， the knife out，a new tool mesh insert press， until the fixed position.

The 2 blade replacement:

Press the outer foil release button， forcibly took the knife head at both ends ofthe cutter head in vertical pulling out from razor， knife heads at both ends ofthe new head vertically into the press， until the fixed position.

Matters needing attention:

1 keep the product dry， do not flatter bunk? Of? 0 ℃ or above 40 ℃ (104 ℃)，subject to direct sunlight， close to the heat source and moisture heavy charge.

2 because the knife net is very thin， if not handled properly， may causedamage to the knife net. In order to avoid the operation on the body， if a knifeor knife head is damaged， do not use a razor.

3 knife head and the knife net is to have used the term， in order to maintain the good effect， suggest you changed regularly (specific operation.

4 do not use salt water， boiling water， cleaning agent， diluent， volatile oil，alcohol wash or wipe the shaver any part.