Features:

1.84 X 84 dot matrix LCD, can show 4 lines of characters

2.Use serial interface communicate with the master processor, the number of interface signal

line reduced greatly, only 8 signal lines including power and GND.

3.Support different types of MCU, such as the arduino, AVR, SPI, MCS51 and so on.

4.Transfer rate up to 4Mbps, can full speed write display data without waiting time.

5.Can use the conductive glue to connect the module with the printed board, without cables. The metal hooks on the module can fix the module on the printed board, which is very easy to

install and replace.

4.LCD controller/driver chip has been bound to LCD chip, the volume of LCD is small

5.Low power supply,the working current in normal situation is lower than 200µA,and has

power-down mode

Connections：

1.RST--------- reset

2.CE---------- chip selection

3.DC---------- data/commands choice

4.DIN--------- serial data line

5.CLK--------- serial Clock Speed

6.3.3V-------- VCC

7.LIGHT------- backlight control terminal

8.GND--------- power negative

Specifications:

1.For Nokia 5110 3V-5V

Package Include:

1 x LCD Module for Nokia 5110

Hi there ,this is our shipping

Chinapost registered airmail:10-20 working days.

the link of tracking: 1. http://www.sao.cn/en/index/home.jsp

&nbs p; 2. http://www.singpost.com/index.php

City-link: 5-10 working days.

the link of tracking: http://www.citylinkexpress.com/

FedEx:5 working days.

the link of tracking: http://www.114cb.com/fedex2.html