Product image


















How to install

● Rear sensors installation

1. The sensors should be placed 30cm (1 feet) from each side of vehicle and approximately 60cm(2 feet) above the ground.

2. Make sure the sonsors have at least 35 degrees of clearance in all directions.

3. Plug both sensors into the control box, matching the colors of the plugs on the sensors to the receptacles on the control box.

● Control box installation

1. Mount the control box ina dry area inside your boost. Make sure the wires are free from object that may pull, crush or cut the wires.
(especially when the boot is opened and closed)

2. Connect the brown (positive) wire from the control box to the reverse light wire in your vehicle. The reverse light wire will measure +12 volts on a volmeter when the ransmission is shifted into reverse. Make sure the vehicle is not running, the brakes are set, the transmission is in reverse and nobody is standing behidthe vehicle when measuring this wire.

3. Connect the black(ground) wire to ground of reverse light wire or a clean metal chassis ground in your vehicle.



※ Caution

Don't attach a control box to a steel plate.(This will impair sensitivity)

※ Notice

You must use noise filter(black and brown wire of the main control box) in case sensor sensing is defectively operated owing to engine noise.

● Digital display installation

1. Find a suitable location to mount the display.(usually near the rear view mirror or driver's side view mirror)Run the brown and black wires from the display into the fuse panel.

2. Connect the brown(positive) wire to the accessory power wire in your vehicle. The accessory wire will measure +12volts on a voltmeter when the ignition is turned to the accessory or run positions but will be off when the ignition isin the start and off positions.

3. Connect the black(ground) wire to a clean metall chassis ground in your vehicle.

Features

● Easy to install by the wireless connection between control box and monitor

● 2 ultrasonic sensors@ 4-stage audio and visual warning: 1.6m(5.2 feet), 1.0m(3.3 feet), 0.6m(2.0 feet), 0.4m(1.3 feet)

● Aids reversing in all weather

● Easy installation

Sound on/off and meters/feet options

1. To program the system, the ignition must be on and transmission must be shifted in revers. Make sure the brakes are set before programming to prevent your vehicle from moving.

2. To turn the sound on the display on or off: Use a small screwdriver to press the switch on the back of the digital display for 3 seconds.

3. To switch the display from meters to feet: Press the switch on the back of the digital display for 6 seconds.Pressing the switch for another 6 seconds will toggle the display back to meters.

Special notes

● Works in reverse gear only.

● For 12 volt vehicles only.

● Sensors may not detect thin objects such as wire, cable, rope, etc...

● Keep sensors free of dirt and other contaminants.

Specification

● Operation voltage: DC 12V

● Electric consumption

1. Control box : 50mA

2. Monitor : 85mAOperating temperature : -20C ~ +60C

● Ultrasonic distance measuring system

● sonic frequency: 40KHz

● Purpose: Backside obstacle detection.

● Length of cable:

1. Sensor cable : 2.5m

2. Control box cable : 4m

3. Monitor cable: 4m

● Measurement:

1. Control box : 70mm x 93mm x 33mm

2. Monitor :74mm x 52mm x 40mm

● Weight : 400grs