LiPo Rechargeable Battery 3.7V 1300mAH

Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 1300mAh.

The batteries come pre-attached with a genuine 2-pin JST-PH connector as shown.

Like most lipos, the batteries we sell do not have thermistors built in. This is why we suggest charging at 1/2C or even less - 500mA max in this case which is how much you can get from a USB port.

Note: Do not use a NiMH/NiCad/lead-acid charger! Also, do not abuse these batteries, do not short, bend, crush or puncture. As with all Lithium ion polymer batteries and with any power source - they should be used by experts who are comfortable working with power supplies.

We recommend using this Lipo with the Shield-Lipo for charging and power up Arduino.

Specification:

• Ordinary Voltage: 3.7V

• Fully-charge Voltage: 4.2V

• Capacity: 1300mAh

• Continuous discharge rate: 20C (26A), but the cable cannot withstand more than 5A continuous.

• Recommend charge current: 0.5C (650mA).

• Internal Resistance: < 7 m Ohm

• Must charge with designated LiPo Battery Charger, recommend using Shield-Lipo

• Please check Wikipedia link about Li-Po Battery.

• Dimension: 35.5mm (W) x 63mm (L) x 7.5mm (H)

• Weight: 30g