JST Plug Servo connector With 1.2V Protective Part And Cable Switch

This connector with switch and voltage control is in order to control the use of servo

and in case of overload current and short circuit.

Wire length: 10.3-14.5cm

Connector instruction

Most of the 2S 7.4V helicopter battery when full of charge、 the voltage is higher than

normal.[It's about 8.4V] But the voltage will lower than 8V [Keeping between 7.4-8V]

when it used little time. So if the voltage of the servo are not stable、 the servo may

burn out or shaking. Actually、 most of the servo can work at the voltage of 6V. In

order to protect the servo、 you need this connector to keep the safe voltage at 6V.

Package
1xServo Connector