There is an expert mode.

Right throttle mode 1. Recording starts with the right button. microSD is in controller. Record the video transferred wirelessly. The left button is a dummy. Flip off when you press the right stick (?). Expert mode by pressing the left stick. In addition to the transferred image being captured, the flight time after the start of the link, the voltage of the aircraft battery (flight start 4 V, thrust loss 3 V) and the remaining battery level of the controller are displayed on the screen. Very easy to use. On the other hand, the loss of thrust quickly after shocking out of batteries, the balance at the time of recovery from the sudden drop is bad. The flying time is about 5 minutes with a new battery. I think it was good to buy.

How to switch to Zoo - tor mode 2

Those with soldering and solder absorbers can do it. (Product warranty disappears. At self-responsibility ... for reference · · ·) ★ To prepare ★ Driver ★ Soldering iron ★ Solder ★ Solder absorber ★ Button battery (CR 2032) (3 V) 1 piece ------- ---------------------------- Work procedure ① Remove the four screws on the back side of the transmitter. ② Remove all board screws as well ③ Remove left and right sticks with solder absorber. ④ Insert the button battery (CR 2032) (3 V) (It is the battery for holding the data) ⑤ Assemble and set the mode 2 as there is a place to put the button batteries in the board. ----------------------------- After that, because the data is kept with the button battery, when you turn on the power, always mode It becomes 2. --------------------------------------------------------

It is difficult but fun

Those with soldering and solder absorbers can do it. (Product warranty disappears. At self-responsibility ... for reference · · ·) ★ To prepare ★ Driver ★ Soldering iron ★ Solder ★ Solder absorber ★ Button battery (CR 2032) (3 V) 1 piece ------- ---------------------------- Work procedure ① Remove the four screws on the back side of the transmitter. ② Remove all board screws as well ③ Remove left and right sticks with solder absorber. ④ Insert the button battery (CR 2032) (3 V) (It is the battery for holding the data) ⑤ Assemble and set the mode 2 as there is a place to put the button batteries in the board. ----------------------------- After that, because the data is kept with the button battery, when you turn on the power, always mode It becomes 2. --------------------------------------------------------I bought it as a present for my father. Although complaining that it does not fly not to fly, when looking closely often, the AB of the propeller is reversed .... I fixed it and it flew properly. Having been touching ... Well ... the manual is difficult to understand in English, the buttons that do not function on the controller are attached, the code of the battery is thin so it is difficult to detach, short drive time etc. Although there are many points to worry about, the controller is light and easy to hold, beautiful pictures projected on a big screen are very attractive. After all the maneuvering is better than the smart stick type like this stick.

Outdoor use feeling

I am fine even outdoors [flying]. If you ride correctly and raise the altitude, you may get drilled (uncontrollable) at the descent due to wind direction. I have gone back to the forest.

ny

It is cheap and has high performance. However, if you have more batteries long 120

I used it normally, but ...

This product is also a good fun product for images, but since the instruction manual is in English, that point, star 1 minus

It's fun!

Drone is the third one, but it is the most fun. Because it is small but powerful, it moves promptly. Even beginners can fly indoors so you can practice outdoors after practicing. Even if it says anything, since the display has a display on the controller, you do not bother to connect the app to the smartphone ... so it's easy to do.