Name: Car 500A battery cable / 2 meters battery cable 12V emergency ride the line of fire ignition wire / Martial Law

Specifications: Cable length: 2 m

  Weight: 0.6KG

[Steps]

     1, a red head and a link cable clip (+) to the positive terminal of the dead battery.

     2, connect the cable to another red clip head (+) to the positive terminal of the good battery.

     3, connect the cable head a black clip (-) to the negative battery good.

     4, the clip head and the other black engine housing or car body is connected to the cable.

     5, at startup, instantaneous operation, there must be 10 seconds cooldown between adjacent two starts.

     6. To uninstall cables were installed in the opposite steps.

[Note]

     1, in strict accordance with the operating steps.

     2. Check the label of two battery voltage, ensure that the same two battery voltage.

     3. Close all the car load, hanging neutral position, pull the brake to get started, start the engine. Smoking is prohibited in the vicinity of the vehicle.

     4, if the car battery is frozen, prohibit start, it may cause an explosion.

     5. Make sure the battery wiring polarity is correct.

     6, the operation, the car can not contact with other vehicles.

     7, the battery will produce explosive gases! Wear protective goggles when installing cable.

     8, if the battery is accidentally leaked acidic substances, splashing into the skin or eyes, rinse immediately with plenty of water and consult a doctor.