【installation method】:
    A. Because some stickers are Paper packaging， stickers base paper， and transfer film some bubbles， and the end of paper， some wrinkles， please note that this is normal， does not affect the paste， transfer film to tear the last.
   II. Posted position kept clean， the official opening of stickers， three cases deal with
   1， dry paste method (within 30 cm of the car stickers applicable): Do not be a little sticky whole put up， and then gradually expand to the other side of this know-how to master the basic no wrinkles and bubbles up. Be careful not to accidentally adhesions， car stickers are disposable， glue on the bad moves. As bubbles posted a good， usable tip or needle point what you can， can not see， does not affect the overall results.
   2， Shimizu paste method (30-60 cm car stickers applicable): stickers with clean water， after the end of paper torn location and car stickers affixed to both uniform spray water， first gently imaginary posted up so you want to adjust the location can be will take down and then spray evenly water and then paste the appropriate location can be scraped off the water gradually.
   3， detergent water paste method (60 cm above the large car stickers applicable): Senate have detergent spray water car stickers put up a good position after adjustment， with water the first half of a detergent rinse water Be sure to rinse oh to spend a lot of water can rinse after rinse， scrape prison side， the other side of the same process can be.
 
 [Removal method]:
   Car stickers would like to get rid of， first with a hair dryer or heat gun roast， following the car stickers gum to soften， then slowly tear strength softer you can tear up the car stickers shop without leaving any offset， do not hurt the paint.