Glue All Purpose No Run Gel Precision Tip .07 oz

Heading	Still stays stuck.
Purpose	Glue
Manufacturer	Borden Inc
Directions	READ INSTRUCTIONS BEFORE USING. Protect work area. Glue may damage fabrics and furniture finishes. Screw cap onto tube. Cap automatically pierces tube. Remove red cap from applicator before use. Gently squeeze tube applying 1 to 4 drops per square inch depending on porosity. Too much glue or spreading glue will make a poor bond or no bond. Parts to be glued should be clean and dry. Parts must mate. Metals may have to be cleaned with a solvent or scraped. Dampen porous ceramics on 1 side and apply glue to dry side. Sand or plane wood surfaces flat. Remove paint glue etc. from surfaces to be bonded. Join the parts and press for 30 seconds. Allow to set for a few minutes. Replace red top over applicator tip. Not for use on paper foam rear view mirrors polyethylene Teflon or other fluorocarbons. Do not put bonded items in oven or on stove. Do not use to attach artificial nails.
Uses	Glues up down and sideways. Fills gaps on less than perfectly-mated surfaces. Forms a strong long-lasting bond. Best for these surfaces: ceramic pottery wood leather rubber metal plastic (PVC ABS FRP) vinyl.
Warnings	EYE AND SKIN IRRITANT. BONDS SKIN INSTANTLY. Contains ethyl cyanoacrylate. Avoid contact with skin and eyes. If eye or mouth contact occurs hold eyelid or mouth open and rinse thoroughly but gently with water only for 15 minutes and GET MEDICAL ATTENTION. Liquid glue will sting eye temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor. If skin bonding occurs soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may cause skin burn. If spilled on clothing flush with cold water. Avoid prolonged breathing of vapors. Use with adequate ventilation. KEEP OUT OF REACH OF CHILDREN.