Weight:1053g
specifications:30.5*22*14cm

RGB LED LIGHT GLASS WATERFALL FAUCET KITCHEN BASIN BATHROOM SINK MIX TAP FAUCET

LH-66.jpg

LH-66.jpg

Product Information:

Brand new in box ready to ship;

  • The LED light is powered by 4 units of AA battery, 1.5V (included in the package), and the light only works while open the faucet .
  • This item will change its color by detecting water temperature;
  • Durable Solid Brass & Tempered Glass Construction;
  • Polished Chrome Finish;
  • When water temperature is<32 degree, Green color will show automatically;
  • When water temperature is between 32~45 degree,Blue color will show;
  • When water temperature is above 45 degree, Red color will show.
  • Weight:1053g
  • specifications: 30.5*22*14cm
  • Tools You Need for Installation

    General Faucet Installation Instruction

    Please kindly note that this is just a general instruction, each faucet you buy from us has installation instruction with details inside package.

    Step 1: Position the Faucet

    A: Begin installing your faucet by placing the gasket and faucet in position on the sink.
    B: From under the sink, thread the plastic mounting nuts onto the faucet shanks. Be sure the large side of each plastic mounting nut is up.
    C: From the top of the sink, check the faucet and gasket position.
    D: From under the sink tighten the mounting nuts, making certain not to over-tighten which could damage the nuts and make them difficult to remove in the future.
    Step 2: Attach the Water Supply Tubes
    A: Wrap the threads of the water-supply valve with Teflon tape. Although most plumbers use only Teflon tape, some plumbing supply manufacturers also recommend using plumbers putty.
    B: Thread the water supply nut onto the shut-off valve. Tighten the nut with a wrench.
    C: Wrap the threads on the faucet shank with Teflon tape, and then thread the water supply nut onto the faucet shank.
    D: Tighten the nut with a wrench.
    Step 3: Connect the Faucet Lift Rod
    A-1: From the top of the sink, insert the lift-rod into the faucet.
    A-2: From under the sink, make sure the pivot-rod is in the down position. Insert the lift-rod into the lift-rod strap. Tighten the screw.
    B-1: From the top of the sink, make sure the lift-rod opens and closes the drain plug as desired.
    B-2: Make any needed adjustments by loosening the lift-rod strap screw and repositioning the lift-rod.
    B-3: If you need to connect the lift-rod strap to the pivot rod, slide one end of the spring clip onto the pivot-rod.
    B-4: Make sure that both the pivot -rod and the lift-rod are in the down position. Insert the pivot-rod in the closest hole in the lift-rod strap.
    B-5: Slide the other end of the pivot-rod. Make sure the lift-rod opens and closes the drain plug as desired.
    C-1: Make minor adjustments by loosening the lift-rod strap screw and repositioning the lift-rod.
    C-2: Make major adjustments by removing the spring clip and moving the pivot-rod to a different hole in the lift-rod strap.
    Step 4: Flush the Fauc

    Payment Terms And Shipping Service:

    Exchange:

    About Us:

    Dropshipping SERVICE:

    ATTENTION PLEASE: