使用说明书（修订版）
1、测试
初次使用时，请先往壶体内倒入清水，水位须高于壶体底部的发热体约0.5厘米，然后接通电源，如果有快慢档功能的型号请设置为快档，此时电药壶会自动加热至沸腾，直至水份被蒸发至低于发热体时，自动停止加热停跳保温同时鸣音提示（绿灯）状态。测试完毕，机器可以正常工作、
2接通电源注意
接通电源的操作，必须先将电线插入机器，再将电线的另一头插到插座上，请勿先插入插座再插机器，操作不当容易引起短路碰火烧焦电线。接通电源时请确保壶体里面放置水，并高于壶体内部发热体至少1CM。
3、两副药一起煲，一副药连继煲
如果有客户希望两幅药一起煲，煲成2碗，这种情况下需要通过手动控制断电，即当你看到约剩2碗水时手动断电，要剩3碗水，4碗水也是同理。
4、放多少药，放多少水，煮多长时间。
放多几碗水都没有问题，（机器会自动工作）。根据机器原理，水位必须高于发热体，并不超壶体高度的70%（防止水量过多而溢出）。一般家庭药材水份低于发热体时倒出刚好1碗水左右（视不同药渣的密度、稠度而有所差别）。一般大人的药草大概200-300克，放置的水份越多，煲药的时间会越长，煮出来的药很浓，效果很好哦。正常煲药的时间快档为1-2个小时，慢档为3-6个小时，通常情况下请使用快档煎制，机器会自动工作。特别需要慢熬的药物请使用慢档煎熬（通常情况下很少）。
5，药壶进入煎药之后，当煎到壶内水位低于发热体，发热体顶部面板温度上升到125°-130°时，药壶会自动由加热状态转到保温状态，此时保温灯亮起！表示煎药完毕，如不需保温可切断电源，倒出药液！一般煎煮一剂耗时约1-2个小时，主要是根据加水多少决定煎药时间长短！水少时间短，水多时间长！
6、药壶处于保温状态，当壶内温度下降到低于70摄氏度，药壶会自动转到加热状态提高温度，反复循环，达到保温效果
7,保温状态不宜太长，一般不要超3-4个小时，避免汤药被药渣反吸和反复加热蒸发，导致最后剩下汤药过少
8.如果需连续煎多次原药，应等药壶温度下降到与自然温度差不多，或用冷水泡上2分钟，然后通电煎下一次药，
9、白色减水陶瓷圈的作用
白色减水陶瓷圈，它的作用在于减少剩余药汤的量，就是煲好后的药量。请在放水时就先将陶瓷圈放置于壶体底部，如果陶瓷圈不慎断开亦不会影响使用的。陶瓷圈的作用煎煮小儿药草填充体积，也可以用普通陶瓷汤勺代替。其作用原理就是占用了底部的空间，使剩余药汤因此减少。
10.以上方法均为煎煮，炖补品及汤料方法与煎药稍有不同，水位同样必需高于发热体1CM以上，
11、注意事项
请勿将壶体放置于水中清洗，会导致底部入水而损坏电路。
插入电线时请先将电线插入机器，电线的另一头再插入插座，勿先插入插座再插机器，容易导致电线短路碰火。空壶测试时的时间不可超一分钟。（有防爆裂功能不代表长时间空壶空烧不爆裂）
如果水份烧干机器依然工作，有可能机器发热体部分有药渣遮到，影响温控器工作，如果测试用清水（没有加药渣）情况依然存在，则机器的温控电路部分出现问题，请联系更换。配合定时器使用免专人看管！（请尽量使药渣不会盖到发热体顶部，而是放置在发热体的周围.
User's Manual (revised)
1, test
First use, please go to the kettle body into the water, the water level must be higher than the bottom of the body of the body about 0.5 cm heating, and then turn on the power, if the speed file features a model set to fast file, then electric kettle Will be automatically heated to boiling until the moisture is evaporated to lower than the heating body, automatically stop heating flashes while warming (green) state. Test is completed, the machine can work normally,
2 Turn on the power Note
Turn on the power operation, you must first insert the wire into the machine, and then the other end of the wire plugged into the socket, do not insert the socket and then insert the machine, improper operation likely to cause short circuit fire burned wire. Turn on the power, please ensure that the kettle placed inside the water, and higher than the kettle body heat at least 1CM.
3, two drugs together pot, a medicine even after the pot
If you want two pots of medicine to burn together, cook into two bowls, in which case you need to manually control the power outage, that is, when you see the remaining two bowls of water manually powered off, leaving three bowls of water, four bowls of water The same is true.
4, put how much medicine, put how much water, cook how long.
Put a few bowls of water are no problem, (the machine will automatically work). According to the principle of the machine, the water level must be higher than the heating element, not exceeding 70% of the height of the pot body (to prevent excessive water overflow). General family medicine is lower than the water heating body just pour a bowl of water around (depending on the density of different dregs, consistency and vary). General adult herbs about 200-300 grams, the more water placed, the longer the pot medicine, boiled medicine is very strong, the effect is good oh. The normal time to burn drugs for 1-2 hours, slow file for 3-6 hours, under normal circumstances, please use the fast file system, the machine will automatically work. In particular, need to slow boil the drug slow down (usually less).
5, medicine pot into the decoction, when the pot to the water level is lower than the heating element, the top of the heating element panel temperature rises to 125 ° -130 °, the medicine pot will automatically go from the heating state to the insulation state, then the insulation light Start! Said the decoction is completed, if not heat can cut off the power, pour liquid! A general decoction time-consuming about 1-2 hours, mainly based on how much water decoction time! Water short time, water long time!
6, medicine pot in the state of insulation, when the pot temperature dropped to below 70 degrees Celsius, the pot will automatically go to the heating state to increase the temperature, repeated cycles to achieve insulation effect
7, the insulation status should not be too long, generally do not exceed 3-4 hours, to avoid the drug daphne anti-suction and repeated heating evaporation, resulting in the last remaining decoction
8. If you need to repeatedly fry the original drug, should wait for the temperature dropped to almost the same as natural temperature, or cold water for 2 minutes, and then power the next time the medicine,
9, white water reducing ceramic ring role
White water reducing ceramic ring, its role is to reduce the amount of remaining medicine soup, is the pot after the dose. Please put the ceramic ring at the bottom of the pot first when the water is discharged, and if the ceramic ring is broken accidentally, it will not affect the use. The role of ceramic ring Children boiling herbs fill the volume, you can also use ordinary ceramic soup spoon instead. Its principle of action is to occupy the bottom of the space, so that the remaining drug soup thus reduced.
10. The above methods are boiling, stew tonic and soup method slightly different from the decoction, the same water level must be higher than 1CM above the heating element,
11, matters needing attention
Do not leave the kettle body in water for cleaning, causing water to enter the bottom and damaging the circuit.
When inserting the wire, please insert the wire into the machine and insert the other end of the wire into the socket. Do not insert the socket first and then insert the machine, which will easily lead to short-circuit and touch the fire. Empty pot test time can not exceed one minute. (With anti-burst function does not mean long time empty kettle does not burn)
If the water is still burning dry machine is still working, there may be part of the heating element of the machine covered with dregs, affecting the thermostat work, if the test with water (no dregs) still exist, the machine temperature control circuit part of the problem , Please contact replacement. With the timer to use someone care! (Please try our best to make the dregs not cover the top of the heating element, but around the heating element.