• A multifunctional HUB with PDB, BEC 5V/2A 12V/500mA, Current sensor 140A, STOSD8.It is specially made for the mini FPV Quad.
    • n
  • 8 - 21V DC input voltage range(3S - 5S operation),continous current 4x30A (Max.4x35A) ESC output,5V 12V BEC output and short-circuit tolerant(2/seconds/minute),140A current sensor.
    • n
  • 2oz copper,4-layers 1.6mm PCB,Dimensions: 46x36x4mm,Weight: 8.5g,Mounting holes 30.5mm square spacing,Φ3mm
    • n
  • 1x Battery input,4x ESC outputs.2x BEC 5V outputs,2x BEC 12V outputs,Camera signal Gnd pads,Video Transmitter Signal Gnd pads,1x Serial port (RX, TX, G).
    • n
  • Built-in STOSD8:Running indicator,Autodetect PAL/NTSC,Dynamic on screen info,Min.Volt Max.Amp recorder,Automatic flight timer,Auto battery cells detection,Low vlotage alarm,Exceeding mAh alarm,Firmware upgradable. More infor How to use the STOSD8 Tool,pls visit: www.stosd.com
    • nMANUAL,pls visit: http://www.mateksys.com/downloads/HUBOSD8-H_EN.pdf
    More info u0026 How to use the STOSD8 Tool. Pls visit www.stosd.com, pls visit: http://www.stosd.com/

    General:
    Input voltage range (3S-5S operation): 8 - 21VDC
    PDB: 4x30A (Max.4x35A)
    Regulated 5V and 12V outputs
    Current Sensor 140A
    Built-in STOSD8


    Physical:
    - 2oz copper, 4-layers u00261.6mm PCB.
    - 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 12V outputs.
    - Camera signal u0026 Gnd pads, Video Transmitter Signal u0026 Gnd pads
    - 1x Serial port (RX, TX, G)
    - Dimensions: 46x36x4mm, Weight: 8.5g
    - Mounting holes 30.5mm square spacing，Φ3mm

    PDB(ESC outputs)
    Continuous current: 30A per output
    Peak current (10 seconds/minute): 35A per output

    BEC 5V outputs
    Designed for RC Receivers, Flight controllers, OSD, and Servos.
    DC/DC synchronous buck regulator.
    Voltage: 5.0 +/- 0.1VDC
    Continuous current: 2 Amps (Max.2.5A 10s/minute)
    Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
    Short-circuit tolerant (5 seconds/minute)

    BEC 12V outputs
    Linear regulator, very low noise. LC Filter is needless.
    Designed for Video TX or FPV camera.
    Voltage: 12.0 +/- 0.3VDC (4~5S operation)
    Continuous current: 500mA@16V IN, 400mA@20V IN
    Short-circuit tolerant (2 seconds/minute)
    If the battery is 3S LiPo, Output voltage=3S LiPo voltage - 1V

    Current Sensor
    140A
    If current >140A. STOSD display 140A