Product size:20x 4x 7.2cm

Feature:

1. 16 segment design.

2. 8 kinds of classic display mode， key settings， settings with memory function.

3. 6 gain settings， press button setting.

KS16 there are 8 kinds of classic display mode， key settings， settings with memory function.

Mode 1: Columnar Mode

Mode 2: Columnar with floating point mode

Mode 3: Columnar with floating point， floating point up out of the mode

Mode 4: Mirror mode， middle to the both sides

Mode 5: Single point mode

Mode 6: Single point with floating point up out of the mode

Mode 7: Single floating point mode

Mode 8: Mute all light mode

Note:
Due to the thickness of the plexiglass error (cannot currently control)， there could be glass with LED is not on a plane phenomenon， please install some plexiglass into the welding a good observation of the PCB， please adjust the spacing between the nut and align each layer of plexiglass with LED.

Package Included:

1x Music Spectrum VU Tower





Gorgeous effect， rounded corners design

Board welding reference: (Note: the components are welded to the silk screen label side)




PCB has been upgraded to the new version， R1 R2 R17 R18 resistance change direction. Pay attention to the chip direction and LED negative and positive side. USB interface is inserted from the back.






4 transparent anti-slip mat at the bottom




Kit:




Best color default configuration:
Mark (471)= 470Ohm resistance

Mark (102)= 1K resistance

Mark (103)= 10K resistance

Remove the protective film:


Pay attention to upper and lower Board differences:


Keystrokes and instructions for use:

Clicks: mode conversion

Long press: gain adjustment， 1-6 will display at the top (recommended value 3-4)

1， Please insert the attached connector USB port to your computer USB interface， 3.5mm headphones by audio two-branch into the computer or other device's headphone outlet， branch and the other a broken connecting audio equipment;

2， Through adjusting the input volume with gain adjustment to control the display amplitude at the approprite range;

3， Please do not use the cottage phone charger or other excessive ripple current and voltage instability of power supply will cause damage to the products or a bottom-to-noise.

1. Please note the LED positive and negative. LED long legs as "+". There is an obvious sign on the PCB Board ， LED screen printing gap is negative;

2. This kit to install plexiglass plate screws need to have some patience. This product uses M4 stainless steel nut， adjust the nut spacing corresponds to the plexiglass with LED;

3. Please do not use solder welding， solder paste electrical conductivity， it is difficult to clean， residue SCM does not work properly or even damage caused by leakage， this phenomenon is beyond repair. Using conventional methods--method of soldering iron and solder wire welding.