Product Name

BETAFPV F4 FC Brushed Flight Controller with OSD Smart Audio (No Receiver) for Tiny Whoop FPV Micro Racing Drone Blade Inductrix

Product Code: PROD50000727

Product Information

BETAFPV F4 brushed FC board bring a new era in FPV whoop technology. STM32F411 100MHz high performance MCU, 30A lower resistance MOSFETs, Build-in Betaflight OSD and polar reversed protection. All of these is backed by the same reliability and warranty of all BETAFPV FC boards.

Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings.

30A continuous drain current MOSFET. Lower to 8.5mΩ inner resistance value (4.5V). It has a noticeable power improvement in low battery voltage status or with 8x20/8.5x20 motors.

No receiver integrated. So pilots could connect any receiver, like the TBS crossfire rx etc.Designed to work with current Tiny Whoop or Blade Inductrix setups

The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.
ASIN코드 : B07HCBKQM4
PROD번호 : 50000727
정보업데이트 : CV.30923 : 2019-02-10 오후 11:10:23