Product introduction:

Name: General LED mirror lamp， rearview mirror anti-collision glue

Voltage: DC－12V

Color: blue， yellow

Size: 16.5X2.5cm

Weight: 6.64

Product features:

1 the use of flexible circuit board and the back of the 3M glue， can be installed on the curve surface mirror， according to the installation requiresproper bending;

2 then turn lights or lights use;

3 high temperature resistant， waterproof material， durable;

4 the use of ultra-thin， ultra bright LED;

5 environmental protection， low power consumption， high brightness，easy installation， a variety of models of general;

Installation instructions:

Method: (a) must be removed in the mirror

1 please bend the same radian with mirror.

2 then forced up.

3 remove the tripod in the car.

4 loose screws， remove the mirror.

5 put the wires from the round tripod put into the car.

6 using double-sided adhesive tape fixed wiring in the mirror below， make it not easy to see the wire.

7 pull the wire to engine room， connected with the lights on.

8 perfect installation.

Methods (two): not to remove the mirror

1 please bend the same radian with mirror.

2 then forced up.

3 using double-sided adhesive tape fixed wiring in the mirror below， make it not easy to see the wire.

The 4 wires along the mirror affixed to the door edge.

5 pull the wire to engine room， connected with the lights on.

6 perfect installation.

7 can still be seen from the rear lights.

8 perfect installation.

Have a look the picture below， flexibility that is quite good， the back isstrong double-sided adhesive， absolutely firm!