产品名称	宠物隔离静电毯 猫狗训练训导器 隔离毯
型号	DN-ZL002
功能特点	1、三档安全强度电击。 2、用于沙发，床，厨房，婴儿房门口等禁止宠物靠近区域。 3、可折叠式收藏方便更节省空间
适配器插头	无适配器
电池	1节9V干性电池（产品出厂不包含，需买家自行配置）
材质	PVC+铜线
颜色款式说明：	老式门、小单门训练垫75*40cm请选浅灰色M-3016； 防跳沙发训练垫30*150cm请选择白色M-1260； 双开门训练垫50*120cm请选择透明色M-2048。
单个重量	净重：0.40 KG 毛重：0.46 KG

Product name pet dogs and cats isolated static mat training discipline isolation blanket
Model DN-ZL002
Features
1， third gear safe intensity electric shock.
2 for sofas， beds， kitchen， baby room door， etc. No pets near the area.
3， foldable space-saving and more convenient collection
Adapter plug
No adapter
Battery
  Section 1 9V dry battery (does not include manufactured products， buyers need to self-configure)


Material
PVC + copper
Color Style Description:
Vintage door， a small single-door training mat 75 * 40cm Please choose light gray M-3016;

Anti-jump training sofa cushion 30 * 150cm Please select a white M-1260;

Double-door training mat 50 * 120cm Please select the transparent color M-2048.

Single weight
Weight: 0.40 KG
Gross Weight: 0.46 KG

产品的组成：

【红包妹子实拍图】

◆保养与清洁 

1.打开静电毯的控制器，垫子可用布和温和的肥皂水清洗。然后冲洗清洁后擦干垫。一旦晒干，重新安装控件。重要提示：不要将电子控制器浸泡在水中。 

2.始终保持在汽车表面和静电垫之间的铺盖一层软布或毛巾。 

◆存储静电垫 
  当不使用时，我们建议您保存静电垫内的电池从控制盒上取出。 

◆擦洗注意事项
  控制盒一定不能弄湿，会影响产品使用性能。

◆故障排除 
LED灯没有亮： 
●检查静电毯是否接通。 
●检查静电毯是否已装入一个9伏电池，并保证正确连接到控制盒内。 
●换一个新的电池。 

毯子没有检测到我的宠物，但LED指示开关已开启： 
●按照程序的“测试静电毯”。 
●控制盒可能松动。拔掉控制盒，检查是否是连接螺栓的问题，放回去重试一次。 
●您宠物的脚可能有太多的毛造成毯子不触发静电。修剪多余的皮毛，露出宠物的爪子。 
●如果垫子潮湿，干燥后重试。 
●换一个新的电池。 

静电毯没有显示“开”的状态
●检查电池已正确放入控制盒内，没有松动。 
●检查控制器是否牢固卡在静电垫。


◆ Care and Cleaning

1. Open the static blanket controller， mats available cloth and a mild soap and water. Rinse and dry cleaning pad. Once dry， reinstall the control. Important: Do not use the electronic controller soaked in water.

2. Always keep the car between the surface layer and the electrostatic pad blanket soft cloth or towel.

◆ memory-static mat
  When not in use， we recommend that you save battery inside the electrostatic pad removed from the control box.
◆ scrub Notes
  Control box must not get wet， it will affect product performance.

◆ Troubleshooting
LED light is not on:
● Check electrostatic blanket is switched on.
● Check whether the static blanket mounted a 9-volt battery， and ensure the correct connected to the control box.
● for a new battery.

Blanket does not detect my pets， but LED indicator switch is turned on:
● Follow the procedure "static test blanket."
● control box may be loose. Unplug the control box， check whether the bolt connection problem， put it back and try again.
● Your pet's feet may have too much hair static electricity caused by the blanket is not triggered. Trim excess fur， exposing pet paws.
● If the mat wet， dry and try again.
● for a new battery.

Electrostatic blanket no shows "on" state
● Check the battery is correctly placed control box， not loose.
● Check that the controller is firmly stuck in the electrostatic pad.