Model: the whole car sealed tape
【品名】汽车密封条 大D型 小D型 P型 Z型
【材质】三元乙丙(EPDM)
【适用于】车门，后备箱门，发动机盖，B柱C柱
部位使用推荐：全车四门8一15米大D
部位使用推荐：全车B柱C柱5米小D或者Z型
部位使用推荐：全车四门底下P型4米
部位使用推荐：前引擎盖小D4一5米
部位使用推荐：后备箱小D3米
温馨提醒：最准确的尺寸还是建议自己测量好了再下单。
施工效果：
增强车体密闭性，起到车内音响声场保真功能，提高空调制冷/制热效率，关门的声音能更加厚实，有中高级轿车的感觉；有效降低风噪、路面噪音传入车内，提升行驶的舒适感，也可杜绝尘土和雨水进入车内，防水防尘隔音作用明显。
【Product Name】 D-type car seal a small D-type P-type Z-type
【Material】 EPDM (EPDM)
[For] door, trunk door, engine cover, B pillar C pillar
Recommended use of the site: the whole car four a large 15-meter D
Recommended use of the site: the whole car B-pillar C column 5 m small D or Z-type
Recommended use of parts: the whole car four P-4 meters below
Recommended use of parts: front small D4 a small hood 5 meters
Recommended use of parts: trunk small D3 meters
Reminder: The most accurate size is recommended to measure their own good orders.
Construction effect:
Enhance the airtightness of the car body, play the function of car audio sound field fidelity, improve the efficiency of air conditioning cooling / heating, the sound of door closing can be more thick, with the feeling of middle and high class sedan; effectively reduce wind noise and road noise into the car and enhance Driving comfort, but also to eliminate dust and rain into the car, water and dust proof sound obvious.
施工方法：
1、对需要安装密封条的部位及密封条平面位进行彻底清洁、干燥
2、选好粘贴位，找准粘贴起点后将密封条从前侧门拉杆下端开始，进行一点点按压粘贴，注意不要有一点拉扯密封条的动作，尽量保持密封条的原形慢慢对准找准的粘贴路径进行仔细粘贴；在门框拐角的位置，密封条要注意很柔和的进行弯曲走型，不要拐弯太急影响美观。另外因为胶水干得很快，所以一次只能涂一公分左右长短，不能图快求急，这样才能保证效果
3、全部粘贴到位检查无误后，将密封条边缘挤出多余的胶仔细清理干净，等一会的时间后用手进行周到细致的按压实在，就可以收工了，这个时候最好不要关门，敞着门等上20分钟后再一次关好门，然后最好等3---5个小时后再开门正常使用
4、粘贴完毕后禁止用手去拉动密封条，禁止在3天内洗车沾水，24小时内尽量的不要反复开关门
5、施工后关门会有点紧，请大家不要担心，在第2-3天的时候就可以正常了
6、请大家在第1-2天的时间里多注意门是不是关好，安全第一
注意：安装位置在关闭之后密封条必须处于受到正压的状态，这样才可以使其背胶完全作用。（注－－正压：压力方向与背胶所在平面垂直）
【Product Name】 D-type car seal a small D-type P-type Z-type
【Material】 EPDM (EPDM)
[For] door, trunk door, engine cover, B pillar C pillar
Recommended use of the site: the whole car four a large 15-meter D
Recommended use of the site: the whole car B-pillar C column 5 m small D or Z-type
Recommended use of parts: the whole car four P-4 meters below
Recommended use of parts: front small D4 a small hood 5 meters
Recommended use of parts: trunk small D3 meters
Reminder: The most accurate size is recommended to measure their own good orders.
Construction effect:
Enhance the airtightness of the car body, play the function of car audio sound field fidelity, improve the efficiency of air conditioning cooling / heating, the sound of door closing can be more thick, with the feeling of middle and high class sedan; effectively reduce wind noise and road noise into the car and enhance Driving comfort, but also to eliminate dust and rain into the car, water and dust proof sound obvious.
Construction method:
1, the need to install the seal of the site and sealing strip plane bit thoroughly clean and dry
2, select the paste bit, identify the starting point after the seal from the front side of the lower end of the lever, a little bit of paste, be careful not to pull the seal a little bit of action, try to keep the seal of the original shape slowly aligned Paste the path carefully paste; corner position in the door, the seal should be very gentle to take care of walking, do not bend too anxious to affect the appearance. In addition, because the glue dry quickly, so only about one centimeter coating length, can not figure fast, so as to ensure the results
3, all paste in place after checking the correct, the edge of the seal squeeze out the excess plastic carefully cleaned, wait for a while after careful and precise hand press, you can close it, this time is best not to close the door The door waiting for 20 minutes after the door closed again, and then the best 3 --- 5 hours after the normal use of open the door
4, after the paste is prohibited to manually pull the seal, prohibit the car wash water within 3 days, try not to open and close the door within 24 hours
5, closing the door after construction will be a bit tight, please do not worry, in 2-3 days when it can be normal
6, please in the first 1-2 days more attention to the door is not closed, safety first
CAUTION: The sealing strip must be under positive pressure after it is closed, so that the adhesive is fully functional. (Note - Positive pressure: pressure direction perpendicular to the plane where the adhesive is)