Product Description

" Steps:

1，Start with the largest decal and apply it to the corresponding section of the Phantom shell.Begin to apply it by carefully lining up the front corner of the decal with the body line of the phantom
2，Guide the decal along the body lines，pulling it back and reapplying if necessary.Only apply light pressure until you are satisfied with the alignment.You can also lightly pull the decal if you find it is not following the body line.
3.Once the body lines are lined up，apply pressure，starting at the top/center and work your way down the contours of the shell.
4.Repeat the same process to the three larger portions of the decal.
5.On the smallest section of the decal，if you find you have overlap on one side of the bodyline，it may be necessary to apply pressure down the center of the decal first.
If you end up with a crease in the vinyl，light heat from a hair dryer，followed by outward pressure will remove it.
-Light heat will also help promote adhesion if a section of the decal is having trouble sticking.
-Bubbles can be removed by poking a small hole and forcing the air out.

Tips:

Install in an area with adequate lighting
Clean the top shell of the phantom ensuring all foreign material is clear of the surface and cracks where the decal is going to be applied.
Start with the largest sections and end with the smallest.
As a final step，it is recommended to use a hair dryer to apply light heat to the decal，to ensure it stays adhered around the contours of the shell
Remove props.

Package include:

1 x set of decal for DJI Phantom 3 (Quadcopter and controller are not included!!!)
"

Feature

State of the art PVC crystal clear over lam on thick proprietary decal material.
Digitally cut to fit DJI Phantom 3 (Drone not included)
All templates are hand made and digitally scanned to fit industry standards.
Removeable adhesive and easy install.
Covers both top and bottom of the unit and also the controller.
Brand : Asunflower
EAN : 6626969626064