According to SCDF regulations, flammable material requires P&FM storage licence to purchase more than 20 Litres. 

Bestchem Methanol (Methyl Alcohol) for Water Injection
Meets military spec: 0-M-232-E

A high quality methanol designed to bring out the power in your motor. This product will improve combustion and increase flame speed allowing higher compression, thus increasing RPM, horsepower, and acceleration.

Super-charged and turbo-charged cars could eliminate the need for an intercooler, which makes the install of superchargers and turbochargers much easier. Methanol has a cooling effect like Super-chargers and turbo-chargers, produce higher air intake temperature due to the compressing of air. Methanol will lower the air intake temperature dramatically, much more cooling than an intercooler.

Bestchem Methanol as cooling agent in water injection system
Bestchem Methanol permits the use of very high compression ratios. Bestchem Methanol acts as a cooling agent and increases volumetric efficiency and is widely use in turbocharged/supercharged engines reducing charge temperature after compression.

Directions: Injection with water/methanol mixture of 50/50 ratio is recommended. This has been demonstrated to be the best for charge/air cooling, excellent detonation control, and controlling cylinder temperature. Except when severe cold climate which requires higher mixtures for freeze protection.

Caution: At high concentration and injection rates, methanol can act more like a fuel than a coolant. As you increase the portion of methanol injected, you are releasing more energy into the cylinder as the combined gasoline and methanol burn. You will increase the cylinder temperature rather than reducing it. Beyond 50/50 ratio, onset of detonation is more likely.

Packing: 20 Litres Drum

According to SCDF regulations, flammable material requires P&FM storage licence to purchase more than 20 Litres. 

Bestchem Methanol Premix (for water injection)

Meets military spec: 0-M-232-E

Water injection, also known as anti-detonant injection, is spraying water/methanol mix into the incoming air or fuel-air mixture, or directly into the cylinder, in order to cool certain parts of the induction system where "hot points" could produce premature ignition. Methanol acts as a cooling agent, increases volumetric efficiency and lower the air intake temperature dramatically, much more cooling than an intercooler. It also permits the use of very high compression ratios. 

Bestchem Methanol Pre-Mix is a blend of 50% deionized water and 50% methanol. Deionized water which is also known as demineralized water (DI water) is water that has had its minerals removed, such as cations from sodium, calcium, iron, copper and anions such as chloride and bromide. Deionised water in laymen terms means purified process water which has most of the dissolved solids removed. Deionized water should be used in the mixture to ensure the accumulation of scale and foreign matter is eliminated, which may contribute to the accumulation of scale and foreign matter in the water injection plumbing system.

Caution: At high concentration and injection rates, methanol can act more like a fuel than a coolant. As you increase the portion of methanol injected, you are releasing more energy into the cylinder as the combined gasoline and methanol burn. You will increase the cylinder temperature rather than reducing it. Beyond 50/50 ratio, onset of detonation is more likely. 


Packing: 20 Litres Carboy




Singapore's only 24/7 Race Fuel, Methanol & Adblue "One-Stop-Shop" now open! Motor sports enthusiasts will be able to purchase VP Racing Fuels, BestChem Methanol as well as Blue Sky Adblue round the clock at 60 Senoko Road, Singapore 758124. 


Visit our ESHOP for more products!

Any enquiries, Please contact us at :
enquiry@best-chemical.com 

or call us at :
+65 6755 2400