ATX power supply tester can test: 4PIN / 6PIN / 8PIN， HDD power connector / SATA power connector， FLOPPY

? ， 20PIN / 24PIN powerful

?????? Power Tester Instructions


1. To test power supply
2. The measured power 24P (20P) plug into a power tester corresponding 24P (20P) socket
3. Check the right side of seven lights (+3.3， -12V， PG， + 5VSB， + 12V， + 5V) is bright， full light as well (usually generic host -5V power lights are not bright)
4. The measured power HDD plug into a power socket tester HDD， view the left two lamps (+ 12， + 5V) is bright， full light as well
5. Unplug the power cord from the HDD tester， then insert P4 (P6 / P8) plug into the corresponding P4 (P6 / P8) socket， view left a lamp (+ 12V) is bright， bright as well
6. Unplug from mains tester P4 (P6 / P8) plug， then insert the FLOPPY (floppy) plug into the corresponding socket FLOPPY see left two lights (+ 12V， + 5V) is bright， full light as well
7. FLOPPY pull the plug from the power tester， then insert the plug into the corresponding SATA SATA socket， view left three lights (+ 12V， + 3.3V， + 5V) is bright， full light as well