SKU: A630

The Receiver Controller receives and stores the signal from remote control， dispensing with traditional jumpers or switches coding with its high confidentiality， large storage， stable performance.  It mainly used in electric doors， windows， lifting equipment， gateways， industrial control， security and protection field (wired to wireless switching system).

Application: Mainly used in electric doors， windows， lifting equipment， gateways， industrial control， security and protection field (wired to wireless switching system)， it can support remote control， which can composite a set of wireless intelligent remote control components， 

The receiver can be used for either learning code or fixed code remote control.  There is 3 output ways you can adjust: Jog/inter-lock /self-lock.

Wireless receiver controller:

Frequency:

A630: 433MHZ

Frequency deviation: +0.2mhz/-0.2mhz

Operating voltage:DC12V

Operating Current:≤7mA

Operating temperature: -40\'C~+80)

Receiving sensitivity: ≥-105dBm

43x33x14mm

Modulation: AM

Encoding Type: learning code Or fixed code

Signal output method to adjust:

Latch-signal/interlocking: Press one button is working ，press another button is stop  ( one channel switch( receiver )need 2 buttons remote control (transmitter)

Momentary-signal momentary/Jog/Non-Latched: Press and hold button->ON， Release->OFF (one channel switch (receiver) need one buttons remote control (transmitter ))

Toggle-signal/self-locking/Self-Latched:  press one button for one time is working .press the same button again is stop ((one channel switch(receiver) need one buttons remote control (transmitter))

Learning and remove method:

It can work with fixed code remote control directly once installed (make sure your remote control is in well condition. You can check the remote control in our shop if needed).

 If you use it for remote control with learning code:
1.Press the learning button (on the receiver)， it means it has been putting in the study when the indicator light are flashing. ---then you press any buttons of the remote control to transmit signal. it means studying successfully when the indicator flash 2 times until the light goes out .
2. it can learn more than 12 PCS 2262/2260(fixed code) or 1527(learning code) chip with the different code wireless remote control
3. remove/clean :press the learning button about 8 seconds ， the indicator turn on to off ， it means the information that you keep have been removed successfully

Note:This listing just 1pc receiver.

 1X Receiver Controller for wireless RF Remote Control

  Faster shipping service is available.

  Please contact us with the item and its quantity for detail.