(Note: please put at the top， the control box to install in the engine coverwhen installed as far as possible not to hit the water， the host is not waterproof)

Installation instructions

1 the LED rider lights installed in the automobile network position， can be used to tie fixed

2 of the red line is connected to the 12V battery cathode， black line is connected to the 12V battery cathode， the yellow line can be connected at the door switch (switch cathode)， open the door to form flashing， improve security at night the door open. Can also be connected to a cathode linebrake， the formation of flashing reference below can brake (recommended:positive and negative power test after installation of the yellow line)

The car Knight Rider lights

1， the LED rider lights installed in automobile network location.

2， the red line is connected to the 12V battery， 12V battery cathode， black wire

Guide to use

Wireless remote control:

1， press the D key is the power on or off

2， press the B key to cycle to choose different model

3， press the C key to accelerate

4， press the A key to slow down

5， a remote control mode

Product features:

1， adjustable scanning speed.

2， Knight Rider lights all using ultra bright LED and long service life， energy saving.

3， the housing using environmental protection groove， temperature resistance， waterproof， shockproof， anti corrosion.

4， the installation is simple， does not destroy the original vehicle circuit