FEATURES

• New and in a good condition
• Top-grade material with delicate workmanship, durable to use
• Uneasy to deform or break
• A practical tool for daily life
• Used for sealing package so as to keep food from deterioration

Specifications

Package Includes

• 1 x Impulse Heat Sealer 12"
• 1 x Free Replacement Elements
• 1 x Teflon Tapes
• How to Use
• 1. No power switch required (auto-control), link the AC power cord with socket, adjust heating time just according to the thickness of sealing-in material; put the plastic bag on the sealing-in surface and press the handle, the circuit will automatically control heating time. The power will automatically shut down when the indicator light goes out. After 1-2 seconds, release the handle to finish sealing.
• 2. Any damage occurs during sealing is because of over-long heating time, please spin the rotary knob anticlockwise to shorten heating time.
• 3. Too-short heating time will cause unstable sealing. Please spin the rotary knob clockwise to lengthen heating time
• 4. If the plastic bag sticks to rubber pressing board, it means the cooling time is insufficient. You must lengthen the cooling time after indicator light extinguishment. Slightly late to release the handle
• 5. Remain the heating time unchanged after adjustment, and no need to adjust it during continuous service.
• 6. Keep AC power cord always inserting on the socket, no electricity consumption when there is no sealing.
• Warm Prompt
• 1. Always keep the sealing surface clean, avoid any residue oxidation on the surface to reduce ribbon heater and lifespan of heat-resisting fabric.
• 2. Don’t use wet cloth to scrub sealing surface.
• 3. Worn-out liner under ribbon heater will cause short circuit and finally damage the ribbon heater. So, it is a must to check up liner condition every time you change ribbon heater. Replace a new one once there is any damage.
• 4. When you have to change the ribbon heater, you must choose a ribbon heater with the same specification to original one.
• Troubleshooting
• The following listed cases are excluded to quality issue
• 1. Repeated usage of heater strip breaks due to autoxidation, which leads to electricity failure, suggest to replace a new one (oxidation under high-temperature is normal phenomenon)
• 2. Inner coil burnout or damage caused by overload continuous usage or wrong operation
• 3. Any man-made damage leads to non-operation cases
• Note: suggest to keep heating gear between 3-5 mode, it helps to extend the lifespan of machine; long-term working on high-gear will easily lead to burn-up of inner parts. If the inner coil is burnt out, the machine will be disposed as scrap.