LED Projection Clock Description Use

 

 Features :

 

   1 · use 5W high brightness LED light source ， low temperature cold light source with long life ( 40，000 hours ) of green energy .

 

   2.360 degree rotating projection lens telescopic focusing.

 

   3 · Advanced capacitive touch switch ， stepless brightness adjustment.

 

   4 · precision clock movements ， LCD display， easy to use single button when the tone .

 

   5 · classic pointer or digital display clock face clock face ， clock face pointer Rome and other digital clock face dial.

 

   6 Projector farther the distance ， the greater the clock face .

Instructions for use:

 

 A · clock movement battery installation and adjustment time

 

Open the product cover side activities ， see the red rope ， pulled out a box unplug the clock movement ， the position of the installed batteries according to the polarity mark into the section "AAA" batteries， such as the batteries are installed correctly ， the LCD will 3 pointer display and move around. At this point can be adjusted by the black box on the edge of the button right time ， every time you press the button， the minute hand beating of a cell， press the button and hold the minute hand moves quickly ， release the button to stop the minute hand move . After adjusting the time ， the movement of the box back to the original installation location .

 

Power supply ， installation and two focus

 

Keep the DC power adapter included with the product head into the DC power jack projection clock ， and then put one end of the AC power cord into an AC power adapter socket ， and the other end into the electrical outlet according to ± bWater on 220V or 110V . Then tap the touch switch ( position shown ) to turn the projector clock ， will be issued at this time lens light ， the light will be projected onto a wall clock image ， this time of the image may not be very clear， please come sliding telescopic lens barrel adjust the sharpness of the image . Projection angle can be adjusted by rotating the telescopic cylinder .

 

Three · Touch Switch Operation:

 

1 · initial power-up， shut off the lights for the state .

 

Bright 2 · tap the touch ( touch duration is less than 0.5s)， lights off control can be achieved .

 

One-click touch lights ; tap the touch again ， lights out， so the cycle . Light is lit or shut off when no change in brightness .

 

3 · Long press the touch ( touch duration greater than 0.5s)， can achieve stepless dimming the lights . When light levels to minimum brightness ， long press the touch ， light levels increased， long press release touch stops changing light levels ， if long press touch for more than 3 seconds， the light levels after reaching maximum brightness does not change . When light levels to maximum brightness， long press the touch ， light levels gradually decreased ， long press release touch stops changing light levels ， if long press touch for more than 3 seconds， the brightness of the lights after the minimum brightness does not change . So the cycle .

 

4 · memory function in case of power uninterruptible power ， brightness， turn off the lights when you touch each click will be remembered ， next click will touch the brightness of the lights when you turn on the lights as the initial brightness.