CONTROL and ELIMINATE MOISTURE in Wardrobes and Storage Areas with the OleeRod Dehumidifier. Perfect for eliminating moisture in cupboards and wardrobes, pantries, engine room, gear lockers, electronics, galley, berths and bilges, OleeRod Dehumidifier invisibly protects your belongings from problems associated with damp and humidity.

Once positioned, the OleeRod needs no attention and is to be on continuously.

Features

• Permanent and maintenance free moisture removal solution
• Eliminates mould and mildew
• Remove odor caused by dampness
• Low energy consumption
• Noise free operations
• Safety mesh protection cover

How It Works:

The OleeRod Dehumidifier warms, dries and circulates air in the confined storage space through a continuous process. As the air is warmed, it expands. The expanded air causes pressure inside the storage space to be slightly higher than the air pressure outside the enclosure. This pressure differential pushes stale air out of the storage area and fresh clean air seeps in to replace the stale air. Keeping your stored valuables protected from mold, mildew, rust and rot. Enclosed area does not need to be fully sealed, vents at top and bottom of storage area work well.

Choosing the right size OleeRod Dehumidifier for the job. Simply measure the Length x Width x Height of storage area ie, 7ft wide X 10ft High X 3ft deep = 210ft3 (use the 24inch model OleeRod Dehumidifier) then compare to the recommended storage area above.

NOTE: Always choose a size slightly larger than cubic area calculated. Remember it is common to use multiple dampp Chasers in a larger installation area. Such as wardrobes.

TIP: If you have shelves above, try ventilating them by drilling some 10-15mm holes. This allows the dry warm air to rise to the next level. Wire shelves work even better.

Technical Specifications