TIMER PROTECTION: Charger provides the maximum charging time for each charging stage. In the event it is wired to recharge a larger than recommended battery, charger will stop charging after maximum stage recommended time and the RED LED will be FLASH slowly. Atthispoint, Battery mustbe disconnected.
REVERSE POLARITY: Charger has reverse battery protection. (Red LED ON, while output leads are connected backwards), Disconnect and correctconnectiontobattery.
SHORT CIRCUITPROTECTION: Charger will turnoff upon detectinga shortcircuit (Red LEDON.
Charge Current: 2A 4A 8A
Battery Capacity(Charging AH): 6--40 10--80 40--160
Battery Capacity(Maintaining (AH): 6--60 10--100 40--200
Parameter:
Model: EP12M248
Type: Smart & Automatic
Output Voltage : 12V
Output Current: 2 / 4/ 8A
Output Volt No Load : <0.5V
Minimum Start Volt : >2.0V
Input Power W / Load : 34-126W
Input Power No Load : 0.3-0.8W
S ize (L*W*H) : 8*3.5*2 (in)
Net Weight : 1.87LB
CHARGINGINSTRUCTIONS
STEP1- Pre Charge: Battery& Electrolyte Level Check
Check the battery electrolyte level (Only for Flooded or WET battery).
If necessary, remove the vent caps and add distilled water so the levels are halfway between the upper and lower fill lines. Check the battery label if it is12V battery or 24V batteries etc.
STEP 2- Connect Charger to Battery
If the battery is out of the vehicle: red to the positive (+) battery terminal, black to the negetive (-) battery terminal.
If battery is still in the vehicle, determine if the vehicle is positively or negatively earthed,
If Negatively earthed (Most Common)–First connect the Red (+) battery charger lead to the Positive (+) battery post and then connect the Black (-) battery charger lead to thevehicle`s chassis and away from thefuel line.