A code and calibration

Code way

In the case of insects or insensitive to the squirrel, the code can be as follows, warning: This operation may undermine the original pairing, non-special circumstances, please use with caution.

1) Insert the USB receiver into the main unit within 10cm of the handle

2) Press and hold the VOL- button and the middle button below OK for 2 seconds, the green light starts flashing, and then release the button

3) The green light stops blinking, the long light indicates that the code is completed

Note: If not successful please re-operation.


Mouse cursor calibration

This remote control with automatic calibration function, manual calibration only when the automatic calibration is invalid.

While holding down the "right mouse button" and Home button for 3 seconds, the light starts flashing

Release the button before the flash ends, keeping the handle still on the desktop

Steady light indicates the calibration is complete.

Note: Keep the handle absolutely stationary while calibrating. If there is movement, the calibration data may be incorrect and need to be re-operated.


B code and calibration

 

Since our products are six-axis gyroscopes, different environments fall from high places. The mule-mule instrument may have changed and then caused a drift of the mouse pointer. About this matter, please charge it and correct it.

 

How to recalibrate:

A: If the cursor is unstable, it starts to move. Press "OK" + "Back" key for 3 seconds, and placed on the level of surface, until the pointer is stable, the surface is calibrated.

pair:

1, press the "volume +" and "volume" button at the same time, the blue LED will blink, enter the code mode.

2, plug in the USB receiver, wait for about 3 seconds, LED will stop blinking, and then paired successfully.

Cursor speed adjustment:

From slow to fast: Press "OK" and "Volume +" key, the blue light flashes, the cursor faster.

From fast to slow: Press "OK" and "Volume -" key, blue light flashes, the cursor slows down.

Pressing "fn" once, the f1-f10 and punctuation will be locked, and press "fn", it will be released.

 

 

Sleep and wake up

To save battery life, extend the battery life, sleep for 20 seconds without any action on the remote control and press any key during sleep to awaken the air mice.

Precautions.

1. Battery level: Make sure the battery level is sufficient. When the battery voltage is low, the cursor stability will be affected.

2. The use of distance: The actual use of the product distance will be affected by the electromagnetic field changes, please ensure that the receiving end is not obscured by metal objects.