Description :
Air Compressor Moisture Water Trap Filter Regulator Separator & Mount Connection
This compressor is oil-water separator
Uses the intake throttle decompression， by force balance and overflow regulator. To change the gas line pressure， first pull out the hand wheel， and then to get any pressure within a predetermined range through the mediation of plastic handwheel.
Clockwise to increase the pressure and counterclockwise to reduce the pressure.
The light and small design， easy installation， suitable for various installation environments.
Stable performance and durability.
Specification:
Material: High-strength aluminum
Size: As the picture shows
Filtering grade: 40
Maximum operating pressure: 1.5 - 8kgf/c㎡
Working temperature: -20 - 70℃
Capacity of drain bowl: 55ML
Capacity of oil bowl: 110ML
How to use:
1. Before using pay attention to check whether the components are damaged during shipping， the connecting member is loose， and then install and use.
2. When the installation direction arrow on the body are consistent with the airflow， and took note that the correct type of tooth and maintain a vertical position.
3. Use the valve or filter regulator， the regulator should first pull up the knob clockwise， the pressure rises， rotates counterclockwise， pressure drop， adjusted to the desired pressure， press the knob to the regulator locked state
4. The filter drain valve， when no air pressure， gouache water automatically. When the air pressure to push up the drainage column， water discharge， after the drainage is complete， open the drain column， the column is automatically ejected down the drain， drainage end， when the water level exceeds the upper limit， please drain immediately， otherwise it will cause adverse dehumidification.
5. When using mist， you should skip the first zero fuel valve needle， the needle is rotated clockwise， reduce the amount of drip，
counterclockwise rotation of the needle valve， drip volume increases and then adjusted to an appropriate ventilation according to need after position
Maintenance:
1. Clean or replace the filter， remove the filter， using an air gun to blow from the inside out， you can re-use
2. Transparent PC cup， remove the PC cup with a clean cloth to wipe， do not use anything that would undermine PC Cup Material chemicals to clean
Packing Includes:
1 x Air Compressor Moisture Filter
1 x Gauge
1 x Fitting
4 x Male connector
Details pictures :
