Ke Luzi fog lamp (New)

Material: ABS plating

Specification:.

Color: bright silver

The installation method

1 the glue surface must maintain the absolute dry cleaning， general cleaning available without fibre shedding cloth dipped in 50% alcohol， isopropyl alcohol， acetone or toluene solution to scrub， after surface solvent cleaning solvent shall be played only after a thorough pasting.

2 products paste， paste before the products shall be required to install the product on thesite to adjust， to determine the location of product installation， and then tore off the red filmpaste. The operation should avoid finger contact with the rubber surface， you should use the beat， so as to ensure the full contact adhesive and wetting.

3 products and components glue， 24 hours do not contact with the water and the big dustcan reach the best cementing power.

4 please please please note: shade to distinguish between left and right. There are L andR. L left， R for right. In addition the lampshade is easy to enter， if you find that， by not into，the lampshade is over， because may be making a serious mistake， lamp placed against the!

5 he prepared a 3M double-sided adhesive in the shade are bonded with a few， The more， the better.

6 lamp on it， bar on both sides must press a (hold for 1-2 minutes). The best with roast gunheating， increase the adhesive force.