Temperature is an important issue on all RC nitro engines， it will greatly affect the performance of the engine. Now you can warm your engine before the race with our TrackStar Engine Heater!

The TrackStar Engine Heater uses technology similar to that used by Formula 1， Indy Car and NASCAR Teams! It will properly pre-heat your engine to 60-70°C in 10 minutes based on ambient temperature. 
     
The TrackStar Engine Heater will pre-heat all the critical parts of your nitro engine， minimizing stress and wear on the engine. It helps relieve the stress on the crank， con-rod， piston and sleeve during warm-up. It also give you a very easy and smooth engine start， with no stress on your starter box. Fuel consumption is much less， as you do not have to spend time warming up and adjusting your engine. A pre-heated glow-plug will increase the life of your plug. It is also perfect for break-in， as it reduces the "pinch" on your new engine. Most importantly， it will quickly pay for itself by increasing engine life and performance!

Features:
• MCU control heating time and heating power for maximum safety.     
• Safety timer: turn off power around 10 minutes automatically.     
• Built-in temperature sensor: to control the output power of the heater.     
• LED indicator for status of engine heater.     
• 12V DC source with low voltage cutoff.     
• Fireproof and heat resistant adjustable cover.     
• Fits all .19~.26 RC nitro engines.     
• Very small， lightweight and compact for quick and easy storage.     
• It's designed to transfer heat effectively and efficiently.     
• Access port on top allows you to start and monitor your engines temperature without having to take the heater off.

Specs:
Input Voltage: 12V DC
Heating Power: 90W
Heating Time: Around 10 Minutes
Low Voltage Cutoff: 9~10V
LED Indicator: Red LED Stays On (Heating)
                     Red LED Blinking (Low Voltage)
Net Weight: 65g
Dimension: Diameter: 63mm / Height: 50mm

PRODUCT ID: 9052000064-0