Step 1 - Back Cover

Remove the battery and memory card from the device.

Step 2

Remove 4 screws from the right side of the camera.
There are two 3.4mm screws at the top.
There are two 2.2mm screws.

Step 3

Remove the single 3.4mm screw on the left side of the camera.

Step 4

Remove 5 screws from the base of the camera.
There are two 2.2mm screws next to the battery compartment.
There are three 4mm.

Step 5

Slowly slide the back cover away from the device.
The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

Step 6

Detach both ribbon cables using a spudger.
Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

Step 7

Remove the back casing from the camera.

Step 8 - LCD

Use a spudger to release the 3 clips between the LCD case and housing.
Put the tip of the spudger in the gap between the clip and housing, then lift up gently to unclip.
Gently lift the LCD from the case, making sure none of the 3 clips reattach.

DescriptionThis is a high quality LCD Screen Display for Panasonic FX37 FX38 / Leica LUX3. It is used to replace faulty screen, this will also can replace screens which have display problems, cracked LCD screens and so on. It is the best replacement for your damaged screen.

FEATURES

Made of high quality material, durable enough
Best replacement for your damaged, cracked or dirty screen
Easy installation, no soldering need
Give your digital camera a new look
It is the best choice for you
Suit for Panasonic FX37, FX38

Specifications

Dimensions	2.24 x 1.65 inch / 5.7 x 4.2cm (L x W )
Weight	0.28 oz / 8 g
Backlight	No
Compatible with	Panasonic FX37 FX38 Leica LUX3
Size	2.80 inches

Package Includes

1 x LCD Screen Display for Panasonic FX37 FX38 / Leica LUX3

Extra Info

Compatibility: Panasonic FX37 FX38 / Leica LUX3