200G Floor Stand Grinding Miller Household Electric Food Grinder，Chinese Medicine Grinder，Food Crusher
instructions for use
1.to cut off the power supply，open crushing machine cover ， crush tank should be no foreign body.
2.close the cover，connected to the power supply，open the switch， make the crusher chamber idling 1 to 2 minutes，to observe any abnormal phenomenon，if do not have， can use .
3.cut off power supply， open the cover， material is loaded，no more than crushing amount，will cover shut，connected to the power and turn on the switch，operation，crushing sound from noise to equilibrium， said grinding is completed， can be turned off.
4.to cut off the power supply，open the cover，crush of the tank is clean with brush.
5.about the first clear grinding groove，use dry heat after wiping cloth， reoccupy does cloth to wipe.
Matters Need Attention:
1.The amount of material input is not exceeded(not more than half of the crushed slot)
2.crushed material must be dry， not wet and grease
3.Just start up， if the material stuck in the blade， the motor can not rotate(Will find the hum of the bass sound)，To prevent motor burn out， shut off the power immediately，Then remove the card material， check the fuse is good or bad， restart
4.General Chinese medicine takes only half a minute， hard medicine only need a minute，Grinding time should not be too long， in order to prevent fine powder fever， sticky groove
5.The machine can\'t long time continuous operation， boot time shall not exceed 5 minutes at a time，if Processing quantity is alot，Have to rest in the middle (pause) to prevent damage to the motor bearing overheating
6.Long time use， when carbon brush and blade wear serious should change the new one (spare parts)
7.When Operation， the work table should have no other items， the mill on the safe table，In the case of the power supply voltage， the power supply should be close to the working table，Power socket must have reliable grounding line，Do not force the drawing power line， to prevent the human overturned ， breaking the mill and other accidents occurred
8.If the motor does not turn， must cut off power supply， Check the power plug contacts are in good conditions， Replace the spare fuse and carbon brush， need a professional to repair it，
9.The machine is in use， it is forbidden to open the upper cover， put hand， brush and other tools into crushing slot， avoid mechanical， personal accident， When you open the cover， you must pull the plug.， To prevent personal accident caused by touch switch， It is strictly prohibited to direct water washing machine grinding groove.
10.If the machine not use， must placed in a dry， clean and ventilated place.
';