????

 

 

 

 

Introduction (Products)
This product is suitable for iPad host. As an endurance super portable backup battery pack can also be used as the iPad protective back cover， strong momentum and excellent protection for your iPad host.
Built-in large capacity rechargeable lithium battery (8000mAh)， most of about five hours of battery life using time host for the iPad.
IPad original AC adapter to charge the battery pack to the saturation takes about 4 hours.
With four battery indicator LED and a battery detection switch， real-time view of the battery pack power， use more convenient.
With of 1PCS big 4pin turn small 5pin USB conversion line.
Electrical parameters:
Input voltage: 5V; Input Current: ≤ 1.5A; 3 quiescent current: !#!lt!*!100μA; 4 output voltage: 5V; Output Current: ≤ 1A
Power display:
Battery detection switch is pressed， the power is turned on， the LED lights are on， the output voltage of 5V output. Then press detection switch ≥ 3 seconds when the power is turned off.
After turning on the power， if no external load， the battery pack will automatically enter standby mode after 3 minutes.
Coulometric detection switch is pressed， such as the charge of the battery pack is greater than 90%， and four LED will light up simultaneously; such as the charge of the battery pack is greater than 70% and less than 90%， the first， two， three LED light at the same time Up; such as the charge of the battery pack is greater than 50% and less than 70%， then the first， the two LED lights is also illuminated; when the charge of the battery pack is greater than 30% and less than 50%， the first LED lights onwards; When the battery pack is less than 30% of the electricity， the four LED lights flash at the same time， prompt the user needs to be charged.







1 shown in Figures 1， 2 and 3 above， the iPad host into the battery pack， and then charging switch on the battery pack to position ON， the battery pack charging the host iPad on the host， there will be a corresponding charge icon prompts . After charging， the charging switch OFF， then host from the battery pack out of the box (above shown in Figures 3， 4， 5).
The battery pack through the supporting USB converter cable connected to the iPad original AC adapter， and then connect the AC adapter to the AC power， you can charge the battery pack. The four LED display pipelined when charging， the charge saturation， the four LED turned Steady display. The charging process， the charging switch to any position shall not affect the charging process.
When charging the battery pack for the iPad host is also available USB converter cable connected to the iPad original AC adapter， the priority will be to charge the battery pack.
The iPad host into the battery pack， and then through the supporting USB converter cable is connected to the PC， you can carry out the data transfer between iPad and PC.
Attention (Note)
1 iPad host when access to the PC through the battery pack， only the host and PC data transfer， you can not charge the iPad.
Charging， the battery pack will start heating， this is a normal phenomenon， in order to prevent overheating， charge the battery pack in the shade.
Do not use chemical solvents to clean this product.
Do not attempt to disassemble， throwing， smashing， or cut with a sharp object， designated battery pack.
Your battery pack away from heat， place the source of fire， and avoid direct sunlight.
Do not store the battery pack in wet or put them into the water.