Lighting up the Darkness
Ever had to change a tyre at night?
Or perform other tasks at night, such as hiking, fishing or night cycling?
While it's possible to use a torchlight, but is there a better way?
Introducing the Cree T6 Headlamp:











Specifications:

Bulb: XML T6
Stalls: light, light, SOS Baoshan
Brightness: 800 lumens
Battery: 2 * 18650
Packing: Color box
Power: 10W
 
 
I. How to turn on
   1. The battery is positive inward (cap side). Negative outwards (aft).
   2. The switch tail. Switch Function Switch Function switch is a heavy press, tap the switch is dimming
 
 
 
II, DC power
1 OUR torch using advanced voltage constant current technology, can effectively solve the LED flashlight on the constant current regulator requirements;
2, Special Note:
  Do not use excess pressure, voltage should not exceed 4.2V;
  Battery cathode forward, not inverted, otherwise it will burn board;
  Note that the control torch temperature changes, to ensure heat dissipation;
  Non-professionals do not open the circuit board;
 
III, How to power with lithium batteries
1, the main battery flashlight 18650 lithium battery;
 
1, Lamp: American CREE Q5 LED, high brightness, the maximum brightness up to 250 lumens, life 100,000 hours.

 
 2, the circuit: 5 files dimming circuit, with anti-reverse, anti-over-discharge function:
 
 As well as single files and third gear (high - medium - bottom - Strobe -SOS distress signal) to choose from, time for a single file or third gear, please explain shot in the remark, will send according to your requirement Notes goods.
 
Three Settings: high - low - Strobe
 
 A. light, current: 900MA
 
 B. Low light, current: 280MA-320MA
 
 C. Strobe,
 
 
 
Shift: power to enter any file, if the duration of less than 2 seconds off, then after the next power shift, power more than 3 seconds with memory function, power or default the next stall.

The first three stalls in current ratio, respectively: 100%, 30%, 5%
 

2, lithium battery characteristics: lithium batteries and battery charging in a completely different way; lithium batteries have no memory, you can always use the charge at any time, do not overcharge and over discharge;
3. The first charge 6 hours at least, after the green light on the charger according to it. We did not need to overcharge.
4, lithium batteries naturally discharge rate when not in use, the approximate daily release its charge of 1% or less, although slowly, but the anti-place too long;
5, pay attention to the battery waterproof, moisture, drop, etc;
6, special tips to use anti-overcharge, anti-reverse, anti-short circuit "three" charger;
7, for a long time do not use the battery should be fully charged to save, normal in about three months and then charge and discharge;
 
Fourth, the torch instructions
1, the torch is in use, according to the torch voltage and battery requirements for selection, not to abuse, to prevent burn circuit boards, different models, different voltage batteries Do not use;
2, in use, when the brightness of the flashlight change significantly when you want to close the torch, causing the battery to prevent over-discharge;
3, cooling techniques: the torch during use, to ensure heat dissipation. Strongly urge the battery is fully charged, it is best to use second gear, this can make the caps and flashlight batteries are extended product life! Hand clenched flashlight is a good heat dissipation;
  Recommendations should be promptly placed lit torches heat to match the heat on or off until the temperature down and then lit to heat;
4, for a description of the torch waterproof, shock, etc., to strengthen prevention;
5, the inner wall of the lamp cup kept clean, absolutely not hand or hard object wipe; remove fingerprints on the lens, the available cotton swab lens cleaner and gently wipe;
6, can not direct people's eyes light flashlight, ultra-bright glare, so as not to affect vision, especially children;
7. If not using the flashlight remove the batteries (one month or longer) to avoid chemical corrosion.
 
V. Safe-keeping Information
1. Do not torch a long-term and sunlight, water, chemicals and corrosive gases and other contacts, to avoid damage to the protective layer torch:
2, in order to maintain the "O" ring and the screw rotating smoothly, 2-3 times per year according to wipe Vaseline oil on its surface;
 
VI. Troubleshooting
1. Check Battery: Make sure the battery has power and insert the battery in the correct direction, do not use different brands of batteries not mix old and new batteries;
2, check the tail cap: Make sure the switch has been tightened and good contacts to ensure that the end cap and the end cap pillars pressed sheet metal ring good contact;
3, note that the cap is loose.
 
This product is a result of extremely high brightness, close to the eyes may make people dizzy direct dazzle, please be sure to keep a good flashlight, do not let children be in direct exposure to the eye
Our Headlamps come 7 days no questions asked Refund or Exchange!


Purchase Now!