1. Widely used in automobile headlights， front lights， taillights of various car models， motorcycle lights and other decorations<br />2. Strongly adhesive ability， good ductility， strong tensile ability， perfectly wrap vehicle body bent and curve surface<br />3. Resistant to high and low temperature， moisture resistant， not easy to degum<br />4. Strong anti-corrosion ability<br />Color: yellow<br />Material: PVC<br />Size: about 12" x 24" (60 x 30cm)<br />Installation instructions:<br />1. Cut out appropriate size according to the size of car lights， in order to facilitate installation， 5cm longer would be better<br />2. Clean the surface of the lights with a towel<br />3. Spray a little bit water onto the surface of lights <br />4. Spray a little bit water to the expanded light film<br />5. Straighten the film and stick it to the light properly<br />6. Remove bubbles with a scraper to make the film neat and flat<br />7. Can be blew dry or heated with a hair dryer. It has better effect if the film is pasted to a curved surface<br />8. After heating， remove bubbles at the curved place with a scraper to make the film flat<br />9. Use a knife to cut along the lines to remove film part outside the car lights<br />10. Then， enjoy the fun of DIY car refitting<br />1 x Light film<br /><img src="http://img6.eachbuyer.com/x9/p100/bt871_1.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/bt871_2.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/bt871_3.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/bt871_4.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/bt871_5.jpg" />