4-Channel RF Wireless Remote Control Duplicator for Garage Doors， Gate Doors， Alarm Systems etc. This is a fixed frequency remote cloner (433.92mhz) for copying 99.99% common fixed and learning code remote controls including Came， FAAC， NICE etc.Clone up to 4 remote signals from 4 different remotes! With this remote cloner you can clone all 433.92MHz fixed code key fobs. This remote is not compatible with rolling/billion code remote controls.Check this link for a video of the cloning process: http://www.youtube.com/embed/FbmauP1X63M    Operating frequency: 433.92MHz    Weight: 0.03kg    Size: 6cm x 3cm x 2cm    Distance: Up to 100 meters    VERY IMPORTANT: This model can ONLY clone fixed code remote controls which operate at a frequency of 433 or 433.92 MHz. It is not compatible with rolling code or billion code remotes or other frequencies (MHz).Contents:1x Clone Remote Control1x Instructions1x Key Chain

Some remotes that use this frequency are listed below.AETERNA: TX433ALIZE: EM2CAPERTO: CPS1|CPS2，ALLMATIC: AEMX1 433|AEMX2 433|AEMX4 433BENINCA: LOT2W|LOT2WMS|LOT4WBFT: TE01|TE02|TE04CAME:TOP432M|TOP432S|TOP434A|TOP434MCARDIN S476 TX2|S476TX4，CASIT: TXS1|TXS2|TXS3|TXS4|MPS TF2E|MPS TF4ECASALI: GeniusDEA: 433-1(237)|433-2(238)|GENIE S(263)|GENIE S263L|PUNTO2DITEC: BIX LS2 DUCATI: TSAW1|TSAW2|TSAW3ELBER: TSAW1|TSAW3|TSAW2FAAC: TM 433-1|TM433 3GIBIDI: TMB 433-2NICE: FLO1|FLO2|FLO4 OPENOUTTMQ 433-4RASTEL: MPSTF4E GRIS|MPSTF4E RJSEAV: TXS1|TXS3|TXS4，TAU: BUG4|250 TS20|250TX4D TELCOMA:TANGO2 SW|TANGO4 SWThis is just a small list - there are 1000's of compatible remotes.

Programming Instructions :1. Simultaneously press the two top buttons on the clone remote until the blue LED flashes. This clears the clone remotes memory ready for programming (this procedure takes approximately 10 seconds).2. Hold the original and the clone remote close to each other.3. Simultaneously press a button on your original remote and one of the buttons on the clone remote and hold until the LED on the clone remote flashes steadily.4. Programming is now complete. Repeat steps 2 > 4 to program more buttons.