Zero Cutter SC02 / SC-C Safe Cutter Safe Children Cutter Knife  Blades Included

(Secure cutter as its blade is embed in!)

Name: ZERO CUTTER (SC02,SC-C)
Brand: ZERO CUTTER
Characteristics: Available with both hands(For left- and right-handers)
Manufacture: ES&D Co.Ltd
QTY: 1SET (cutter / refill(with case))
Country of Origin: South Korea (Made in Korea)

* Performance
From straight lines to curves, as its sharp cutting angle, it's much easier to use than scissors.
* Safety
Blade is fully embedded in the cutter, safe to use and reduce injuries.
*design
Distinctive curved design that never has been seen from existing products before.

[Our Brand] ES & D
ES & D is the best at reducing even just a minor injuries caused by careless use.
Even from your pocket to pencil case, It will never hurt you. ES & D finds the value from safety.

Everything you see, Everything you touch must be beautiful.
Product of ES & D constantly strives to understand your senses.
Constant study of design makes its design that can be shared with user's fresh inspiration.
ES & D will complete the value with its design.

[Product Guide]
This item is developed and produced by a promising venture company  ES&D's patented technology.
As for ES&D's prdoducts, all of them are made and being managed in Korea to maintain stable quality.
This product can cut paper with a little force. It can cut 1 to 6 pieces of paper.(A4 standard paper)
Bulit-in blade, reduce injuries when you cut the paper,

[How to use]
**cutter**
When using a ruler, put the cutter closly to the side of the ruler.
Press soft enough to cut paper.
Use the thin side of the ruler when you use.(if no ruler, can be used with paper that is thick as much as business card or name card)
Must press the ruler strongly and accurately.

* You can cut not even straight lines.
* You can cut 6 pieces of paper all together. (A4 paper standard)
* Good in using to open envenlope or gift box.
* When using for left-hander, switch the blade to the other side.

** Blade Case **
1. Press the blade strongly that is seen on the case and push it out.
2. Push it out only the first portion of the blade to be seen, and cut the blade using Cutting Clip. (See with the picture description)
3. When it's too hard to pull out the blade, press it strongly and pull the whole blade out and put it back and start again.
4. Place Cutting Clip back on the case in 90 degree from the case and turn it to as it is placed.
5. Cutter case has 10 blades that are refilable. Blade's size is standardized, it can be refilled with other blades in general.

** How to refill blades**
1. Press the Cutter Clip on the case and turn in to 90 drgree and seperate it from the case.
2. Using the Cutter Clip, press the blade perpendicularity and pick out. (You can use the other product that is strong enough such as plastic or wood)

    *If it's too hard to pick out the blade, use a tweezer or a strong magnet.
3. Insert a piece of the blade into the cutter. There are built-in magnets,you can only connect it to its entrance and it will be inserted itself comfortably.