3D printer -Ultimaker PCB control board DIY kit<br />Compatible RAMPS1.57<br />Support double play<br />Size: 175 * 80mm<br /><br />Explanation<br />    This product makes Ultimaker UltiStepper drive is compatible with Pololu stepper driver boards. It supports up to 5 stepper motors. It is designed to run at a higher voltage than 12 volts.<br />NOTE: Jumper (near VR tube 7812TV), Arduino MEGA Ultimaker control panel will also have the power.<br /><br />Feature<br /><br />     1, a simple 4-way plug all motors JST connector.<br />     2, can control up to five stepper motors, can optionally add another axis by adding a Pololu stepper drives.<br />     3, configure step through jumper .<br />     4,3 times the output MOSFET 55 Amps (with LED indicators. The actual current limited capacity PCB and connector)<br />     5. All leads are breaking the maximum scalability from 15V to 19V.<br />     6, thermocouple input or thermistor input. 100K thermistor recommendations.<br />     7,  power / switch board.<br />     8, thermocouple wires easier.<br />     9, (normally open) fan-cooled electronic device includes a 12V regulator.<br />    10, can now be software controlled LCD backlight dimming.<br /><br />3D 1.57 MPU * 1<br />Static bag & carton packaging<br /><img src="http://img6.eachbuyer.com/x9/p100/eb4323_1.jpg" / noproxy>                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb4323_2.jpg" / noproxy>                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb4323_3.jpg" / noproxy>                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb4323_4.jpg" / noproxy>