It can detect the movement of people.
The leds lights turn on when people enter into the detecting area.
And the lights turns off within a delay time about 15s when people leave.
Sensing range up to 10ft,120-degree.Only work in totally dark places.
Small size: 7.68 x 1.26 x 0.71 inch (LxWxH)

PIR Motion & light sensor: At dark place, it will light up automatically when you get into 10ft detection range,
and auto go out 15 seconds after you get out of the range;
Three modes
ON: constant lighting
OFF: turn light off
AUTO: auto-sensing state, light up automatically in the dark when motion is
Compact motion sensor LED under cabinet light adopt with high bright Epistar 5050 LED light source, combining passive infrared (PIR) technology to detect motions.
Under AUTO mode, it will light up automatically in the dark when a motion is detected and auto turn off for hands-free convenience.
Easy installation: magnet and 3M adhesive tape, could be hung and stick-on No tools, screws or nuts are required when installation.
Detection range: 10ft
LED life: Above 80000h
Delay time: 15seconds
Input voltage: 5V DC
Brightness: 250lm
Strip Length: 1m
Color Temperature: 3000K-5000K
Working temperature: -10 ~ 50℃
Motion angle: 120°
Notices
-As built-in photo sensor, it may not work in AUTO mode in daylight or bright surroundings.
-Non-waterproof, do not use it in any heavy humidity or low temp location.
-Try not to mount 2 lights so near. They may interact each other in AUTO mode.

Human body induction in the range of 3-5 meters infrared sensor temperature automatically light lighting during the period of induction to the human body.
the light turn off when people go out 20 seconds later.
When the ambient environment is brighter, it automatically sleeps and the daytime automatically save electricity.
When there is no light at night, the movement of the human body is sensed and the illumination is automatically started.
Side shine and soft light will not stimulate your eyes that open from sleeping.
Adhesive design can you put this lamp anywhere like stairway and bedroom.
Being able to help people get up at night to drink water and feed babies.

- 2 sensors: Light sensor and and sensitive Motion sensor, save energy
- Solar Powered, easy for installation
- Auto identify day or night
- Switch inside for saving power during shipment
- Charge by free sunlight and light in dark when people near around 10ft close
- Green power, Green lighting
- UV protect ABS body, never fade
Solar panel: 5.5V 0.55W, 17% efficiency
Li-ion battery: 3.7V 800mAh
LED: 0.8W, 20pcs 2835 SMD LED
Lumens: 80lm
Waterproof: IP44, Note: but can not put it in the water.
LED Span Life: 50,000 hrs
Solar Charging Time: 8 hrs
Lighting Mode: Dark/ DIM/ bright, DIM: weak lighting for saving power, Bright: motion activate for lighting
Protect Function: over charging, over discharging, over current, short circuit
Li-ion Battery Span Life: 500 circles
Solar Panel Span Life: more than 5 years
Operation Instructions:
- Unlock and activate the device: Use the supplied key pin to click the on/off socket to unlock the battery and light.
- Install the device: Use the supplied expansion pillar-hinge and screws to install the light to where you want.
- Charging Via solar panel: Install the panel south facing in order to make sure there is enough sunlight.