The inch reading blade is graduated on one side, upper edge in 1/32'', lower edge in 1/64''

Technical Details

Product Details

Package Dimensions
Width : 3.1 inch
Height : 0.8 inch
Length : 3.2 inch

Shipping Weight: 0 ounce (View shipping rates and policies)

ASIN : B000VDZAZQ

Product Description

The sliding blades of this tool and die makers'' square can be adjusted at an angle (up to approximately 10 degree) with the beam for measuring the clearance in dies. The larger knurled thumb screw locks the blades at any position, and the smaller one tilts the blades at an angle. To set the blades at an angle, first release the blade clamp screw, then the blade may be tilted to the desired angle by turning the small knurled screw into the beam. The blade can be held in position by tightening the clamping screw. Head and blades are hardened and ground. The narrow graduated blade has 1/32'' graduation on one side, and 1/64'' on the other. It is 5/32'' (4mm) wide over a length of approximately 1-5/8'' (41mm) and cut away at one end to a width of 3/32'' (2.4mm).