The width of the cloth strip is about 25mm. It can help you to make the edging width less than 7mm. Straight stitch， zigzag stitch or decorative stitch can be used.

1. Before installing the presser foot， insert the bead into the guide groove of the presser foot， making sure that the edge of the bead is aligned with the guide groove of the presser foot;
2. Pull out the trim strip from the rear of the presser foot;
3. Install the presser foot;
4. Adjust the needle position until the needle drop point is at the edge of the trim.
TIP: If you can not adjust the needle to the appropriate position on the trim， you can loosen the screw on the presser foot and move the adjustment guide slot to the left or right.