图案: 其他
材质: 3D立体贴
贴膜类型: 车身贴
Pattern: Other
Material: 3D stickers
Type of film: body paste

适用车型：全车系

铝合金/锌合金
圆形直径为7.5cm
八角形直径8cm
长形的为12*2.5cm
单个装 自带背胶
安装方法

1．清洁需要粘贴标牌的位置(必须是完全服贴，切勿贴非平面)，确保粘贴位没有残留物、灰尘，并且干燥。
2．将车标底座的保护膜揭下来，顺标牌从上而下推，再次按牢即可。
3．请不要重复粘贴，因为重复使用会使车标的粘贴性变差。

注：粘贴后24小时请勿洗车。
Applicable models: the whole car

Aluminum alloy / zinc alloy
Round diameter of 7.5cm
Octagonal diameter 8cm
Long for 12 * 2.5cm
Single loaded with adhesive
installation method

1. Clean the location where you need to paste the label (must be fully affixed, do not stick to non-flat), make sure that there is no residue, dust, and dryness.
2. The car standard base of the protective film off, along the signs from top to bottom push, press again can be.
3. Please do not repeat the paste, because the reuse will make the mark of the paste worse.

Note: Please do not wash the car after 24 hours.