• Progressive Tone Stimulus- A warning tone will be issued first, then a shock stimulus if your dog continues to move closer to the boundary
• Pulsed Proportional Stimulus - The closer your pet gets to the boundary, the more intense the shock
• Power Boost Switch -The width of the warning can be adjusted by field width adjustment knob in the transmitter
• Audio Wire Break Alarm- The system▽s control center has an audible alarm to alert you if it senses a break in the wire or if the boundary system is not functioning correctly
• Speed Detect Anti-Run Through- The faster your dog is moving, the quicker the higher level of intensity is issued
• Visual Wire Break Alarm- The system▽s control center will light alsoup if it senses a break in the wire
• Quick Disconnect Terminals - quick and secure connection or disconnection of the wire to the control center
• Low Battery Indicator - When the light on the collar is green, it is working properly
• Red it means time to replace the battery

CAUTION:

Please take a few minutes to read the instruction manual prior to your first use. It is very important to read the manual before using this system. The collar is not fully waterproof, pleas stay away from water like swimming when used.As this product is a wireless transmitting apparatus, you must not use the remote control system in places like petrol stations or hospitals where mobile phones are prohibited. For best results, follow these important rules:

1、The electronic dog collar is intended only for use on dogs. 
2、A low battery may cause intermittent operation. Do not  use if you suspect a low battery.
3、Allow your dog to get used to the collar before you begin training. You want your dog to accept the collar as part of a routine, not to associate the collar with correction.
4、Do not leave the collar on your dog for more than 12 hours per day.
5、Never perform set-up procedures when the collar is on your dog.
6、An electronic collar should only be used under close supervision by the dog▽s owner.
7、Keep out of the reach of children.
8、Read all instructions before using this product.

This hidden fencing system is among the most reliable, cost-efficient pet containment systems available today. A buried wire transmits a harmless radio signal. When you dog approaches the boundary, the signal causes the dog’s collar receiver to deliver a warning beep first. If your dog continues closer to the boundary, the system will issue a mild shock. If your dog continues further, the system will issue stronger shocks until your dog returns to within the boundary your have set up. Your dog will naturally seek to avoid correction, and is content staying within established boundaries.

Easy to setup:

FEATURES

• Sturdy nylon collar is adjustable for most dogs from 15lbs to 115lbs
• Prongs are designed to work on dog with long or short fur
• Comfortable design can be used without irritation
• Battery:Collars use a common 6-volt 4LR44 battery (28A battery made by Duracell, for instance)

Specifications

Package Includes

• 1 x Smart Dog Electronic Fence Collar In-ground Pet Fencing System

Extra Info

How it works:

Wall-mounted transmitter: Transmitter is the central controller to whole electronic system. Make sure the wire is set to a loop.

The receiver collar: Receiver (collar) will make a warning beep firstly and then continuous stimulation if your dog attempts to approach wire boundary.

How to install the system

1、Design your containment area and calculate the amount of wire needed.
2、Install the wall transmitter.
3、Lay out the perimeter wire.
4、Connect the perimeter wire to the wall transmitter.
5、Verify transmitter is functioning without problem.
6、Set up the receiver and then, test the containment system and adjust the field width.
8、Install the boundary wire and training flags.
9、Fit collars to your dogs and train your dogs.

10.The attached battery in the package is only for testing. It is advisable to change a new battery for normal use.