DCS 1800mhz signal booster DCS signal repeater

 Parameter data Uplink Downlink
 Frequency Range      DCS   1710-1785mhz     1805-1880mhz
     [===Not sure which Frequency your Phone Works ?===]
 Output Power           20 ±2dBm 20±2dBm
 Gain                               65  ±2 dB 65  ±2 dB
Bandwidth                        60M
Ripple in Band             PCS≤ 5dB
Spurious Emission           9KHz~1GHz ≤ -36 dBm
1GHz~12.75GHz ≤-30  dBm
          VSWR  (Voltage Standing Wave Ratio)                ≤3
          MTBF  (Mean Time Between Failure) >50000 hours
Power Supply                     AC:100~240V， 50/ 60Hz;DC:9V 2A
Power Consumption       < 5 W
Impedance                     50 ohm
Mechanical Specifications
RF Connector             N-Female N
Dimensions (D*W*H )         182   *  125  * 20   (mm)
Net weight                             0.52  Kg
Installation Type               Wall Installation
Environment Conditions   IP40
Humidity                           < 90%
Operating Temperature           -10°C ~ 55°C
Package Weight           2   KG
 Package Size       510*200*150mm(L x W x D)
Product included 1* 12dB outdoor antenna
1* 3dB indoor antenna
1* RG6-50 OHM  indoor Coaxial Cable-5m
1*RG6-50 OHM outdoor Coaxial Cable-10m
1*mounting accessories
1*AC power supply(European)
1*user manual 

NOTE:This product will be shipped with adapter plugs for the country of the buyer.

Signal repeater installation diagram:


How to install repeater (very easy and simple):
Step 1: Use your mobile phone to test signal strength outside house or on roof， -70dbm is the basic requirement (full bar). 
Step 2: Install outdoor antenna in that location and keep adjusting， point it to signal tower station， try to get the best signal. 
Step 3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.
step 4: Mount your indoor antenna with signal repeater
step 5: Power up signal repeater device to check the signal inside， moving outdoor antenna until you get a satisfied signal.
 
Note:
Connect outdoor (BTS) port with outdoor antenna， connect indoor ANT(MS) port with indoor antenna， outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.
Indoor and outdoor antenna must be separated by wall.

Signal problem & installation technique support:
1.If signal still weak after installation， please check if outdoor antenna point to signal tower correctly or elsewhere has stronger   
    signal and confirm signal strength achieve-70DBM.
2.If still have no signal after installation， please check our device power adapter whether connected perfectly. And connectors
    works well.
3. If strength is not steady， please check if outdoor and indoor antenna is too close; please ensure outdoor antenna has distance of 
    10 meters at least， with a barrier and not in a same horizontal line.
4. Packed the outdoor connector by waterproof glue， otherwise the wet will reduce the signal cover area.