Looking for the ultimate power system for your next Multi-rotor project? Look no further!
The Turnigy Multistar Outrunners are designed with one thing in mind - maximizing Multi-rotor performance! The V2 Series have all the same internals and dimensions of their predecessor， and are compatible to be used together if you’re looking for replacements. The difference is the prop mounting features， The V2 now has a removable/replaceable prop shaft for those unfortunate crashes as well as direct bolt options propellers. There will be replacement prop adapters in CW/CWW rotation， available soon

The 2206-2150KV V2 Multistar nicknamed the “Baby Beast”， is the monster motor for the small 250 class Quadcopters! Designed for 5 or 6 inch props， this motor has power on tap， and ready for your fully loaded 250. The motor has been beefed up in all the right places for FPV durability， with 3.17mm center shaft， 11mm prop flange and a 5mm prop shaft， there is no need to worry about the occasional tree in the way. It’s fitted with shimmed and pre-loaded bearings and high grade silicon wires. If you’re looking for more power， durability and value for your sub-300mm multirotor， think…. Multistar 2206 the Baby Beast 

Multistar is simplifying the world of Multi-Rotors with their purpose built product line and taking the guess work out of your setup.  

*Note: lower mounting screw length is critical to check. The lowered housing was reduced in height to make a nice compact 2206， the tradeoff is the motor winding is closer to the bottom， so overly long mounting screws could potentially contact the windings and damage the motor.

Specs:
KV(RPM/V): 2150
Lipo cells: 2~4s
Max Power: 120w
Max Amps: 10A
Dimensions(Dia.xL): 27 x 17mm
Motor Shaft: 3.17mm (5mm prop shaft)
Prop shaft: 5mm or Direct mount with 9mm center to center
Weight: 30g
Bolt hole spacing: 16mm * 19mm
Connectors: 2mm bullet

PRODUCT ID: 9192000207-0