Product introduction:
First a brief introduction:
The latest ML102-V9.0 Ultimate Edition shelves! Master chip IP5206， synchronous rectification， charge and discharge one
Support 5 battery indicator light;
Support 1.5A charging off schedule 0.5%;
Supports adaptive charging head， 5V1A can charge;
Support 1.5A discharge， average discharge efficiency of 92%;
Support 20 seconds automatically shut down (continuous output current of less than 50mA automatic shutdown， shutdown quiescent current 50uA;
Support load automatic wake-up access
Charging treasure ML102-V9.0 version Features
Charging:
1. Input voltage 4.5-5.5V
2. Charging 1.5A synchronous rectification， support adaptive charging head， 5V1A the following charging head can also be used， as long as 2.5 hours full of 2600! Charging speed comparable MAX1879;
3. Charging accuracy 0.5% accuracy of the measured off about 4.18-4.21V， charging accuracy comparable MAX1879!
Discharge:
1. Output 5V1.5A synchronous rectification， the average discharge efficiency， found 92% support at 18650 full power 5V2A output， charge mobile no heat can be put back pocket to use， compact and convenient
Details:
Ports
LED status light:
NOTE:
1， only height 65mm flat 18650 lithium battery can be used on the ML102.
2，Do not put this product in the travel bag in to charge the phone， because there will be heat generated during discharge.
3， This is just the price of ML102 charger，it does not include USB to micro USB wire， the phone，the 5V 1Acharger or the battery
NOTE:
Because of the Russian postal policy adjustment， buyers need to fill in the full name to the consignee name，then can pick the parcel normally. So please offer us your full name to make you pick your parcel well
Note: the price does not contain line， power supply， battery， FOR iPhone mobile phone
Package included:
1 x power charger
Picture:
About the indicator lamp:
1， the no-load: two green light (including a flicker is normal)
2， to the 18650 charge: charge， two red light， filled with red lights turn green. He was a light that is full of. Blue light has been slightly lighter.
3， 18650 to the mobile phone /GPS/MP4 charging， the blue light. 18650 when the battery is dead， the little blue lights. ML102 automatic shutdown.
Remind: only to see the light white， black and gray can not see
The new ML102 is 1000mA charging current default， and a new 2600mAH Sanyo shallow blue head 18650 battery needs 4-6 hours， but also the size of the internal resistance of battery internal resistance concrete time， the secondary battery charging time is long
Some of my friends say I am introduced too professional. It is easier to say:
The charger can charge the mobile phone， is charging mobile power boost one of the finished product.
A section of 18650 lithium battery into charger， there will be a voltage output of a 5V， can be used for charging a mobile phone /GPS/MP4 and other digital products in your mobile.
Special remind: do not travel in the ML102 charging bag for mobile phone， ML102 discharge when there will be heat， put in the bag will cause the heat can not be dissipated， easy to cause accidents! Avoid by all means!
Charger performance are as follows
A: there are three ways to boost start:
1 for the first time in the cell can be activated. (starting with blue light light discharge display， highlight) remove the battery again will not be able to boot booster (you can use this method to shutdown the boost output)， need to get the battery， wait 10 seconds， and then into the battery will start (strongly recommended. This boot booster)
2 will be on the USB output line shell， is negative， touch input USB shell (or move the power head and tail plug)， this will put MOS shorted out， boosting can start. (this is not recommended to start)
3 will reverse battery， and then are connected， can boost up. (this is not recommended to start)
Two: short circuit protection -- boosted output short circuit protection， short-circuit current of 0. After a short circuit， need the battery， wait 10 seconds then add can boost up again.
Three: the overdischarge protection - voltage discharge protection， over discharge detection voltage 3.0V， discharge， voltage rise， boosting IC does not start， that is not the case of hiccups. If the battery voltage up to 3.2V above， take the battery wait 10 seconds into the， boost circuit can be started. In actual measurement， sample over discharge detection voltage is 2.9V. The measured 2.8V completely off， then the voltage rises to about 3.6V. Voltage detection IC bought over discharge detection voltage is 3.0V.
Four: reverse connection protection， reverse battery not board， mobile power and not burning plate inserted (don\'t try to do the operation， do not know will not appear unpredictable situation leads to the board)
Five: the output voltage - boosting output voltage 5.0-5.2V (IC output is a certain error， is set (5.17V)
Six: output current: not less than 500mA， normal 600mA， maximum 700ma. (conservative value)
Seven: output efficiency -- flashlight places the measured 85%-91 direct%， battery voltage， high efficiency， low voltage， low efficiency
';