| MS8910 SMART SMD TESTER |
| Features:
|
The Tester is a handheld and battery operated very convenient small Tool that is specially used to measuring SMD (Surface Mounting
Device)， there are Chip type resistor， Chip type capacitor and diode， for example. Moreover， the Tester have the continuity checking function
The Tester is automatically identified the passive Component as has been indicated above. Therefore， the measurement are allowed by fully automatic detection. The Tester is designed to meet IEC1010-1 standard and Stipulation of 2-Poulation Grade. The Tester conform to the European Unions following Requirement: CE regulation 89/336 (EMC Electromagnetic Compatibility)
The entire outer surface of the Tester case has been with thermo plastic elastomer， and the two testing pins has been gold-plated， so that it is reduce pin contact resistance and prevent to get rusty.
This operating instruction covers information on safety and caution， so please read relevant information carefully and observe all the warming and note strictly.
| Resistance | ||
| Range (?) | Resolution (?) | Accuracy |
| 300 | 0.1 | ±(1.0% of rdg + 2 digits) |
| 3K | 1 | |
| 30K | 10 | |
| 300K | 100 | |
| 3M | 1K | |
| 30M | 10K | ±(1.2% of rdg + 3 digits) |
| Capacitance | ||
| Range (F) | Resolution (F) | Accuracy |
| 3n | 1p | ±(2.5% of rdg + 3 digits) |
| 30n | 10p | |
| 300n | 100p | |
| 3μ | 1n | |
| 30μ | 10n | |
| 300μ | 100n | ±(3.0% of rdg + 3 digits) |
| 3m | 1μ | |
| 30m | 10μ | |
| Continuity | The buzzer will sound if the resistance is less than 30 ohms | |
| Diode Check | Testing current: 2mA | Open Circuit voltage: 2.8 V |
Accessories:
1) Two free replace test pins;
2) English manual;
3) Plastic carrying case;