1.Anti fog glass.2.CMOS imaging sensor.3.Support NTSC video system.4.Embedded mounting in rear bumper.5.Snap-in design， it is easy to install.6.High sensitivity and low power consumption.7.High-definition and 170 degree wide viewing angle.8.Water-proof， shock-proof and anti-jamming functions.9.Applicable to variety of vehicles: car， truck， RV， etc.10.It helps to avoid incidents and accidents abrasion well.11.Extra-low illumination of 0.5 Lux for clear night vision. 12.Its simple and modest design and small size won't draw any attention.13.This camera can give you a full sight of the back of your car when you are driving. 14.Low illumination level， it can work within 3 meters at night and other dark environments.15.To protect your car from collision with invisible obstacle， choose a high definition and good quality camera as ours. 16.Perfect solution to get rid of that poor rear view visibility onyour car， boat， trailer， camper， truck or any vehicle that has no rear-view mirror or poor rear vision.17.Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted inside will fit into most vehicle key holes， no other installation needed. Specifications:Lens: 2.0cmColor: BlackTV System: NTSCS/N Ratio: >48dBNet Weight: 134gWater-proof: IP66Power: DC 12V±10%White Balance: AutoSync. System: InternalVideo Cable Length: 6.0mVideo Output: 1.0Vpp， 75OhmLength Angle: 120~170 degreeCable Length of Camera: 56cmScanning System: 2:1 InterlacePower Supply Cable Length: 41cmImage Reverse: Left-right mirrorHigh grade of waterproofing: IP66Horizontal Resolution: 420 TV linesCamera Size: 3.5(W) x 2.5(H) x 3.2(L)cmEffective Pixels: NTSC: 510(H) * 492(V)Current Consumption: No More Than 300mAImage Sensor: CMOS 1/4 MT9V125 or PC1030， colorMinimum Illumination: 0.2 Lux/ F1.8(0 Lux with LED)Storage Temperature: -30℃ to + 60°C， 95% RH maximumOperating Temperature: -20℃ to + 60°C， 95% RH maximumElectronic Shutter: 1/50 to 1/100，000 seconds， 1/60 to 1/100，000 seconds Installation:1.Mount the camera inside the keyhole of your vehicle.2.Adjust the lens of the camera to its best position.3.Connect power cord to connect to your vehivle DC 12V power system.4.Connect the video output(yellow) of the camera to the display in your vehicle. Package Included:1 x Video Cable 1 x Power Cable 1 x User manual 1 x Car Rear View Camera 2 x Screws(For Bracket Mount)